Search results

  1. OF

    Arizer Solo

    Good luck, remember not to completely discharge the battery (PA uses a small amount of battery power), since the charger is dead if you do (discharge the battery) you'll have to remove it and charge externally. OF
  2. OF

    Ascent Vaporizer by DaVinci

    The difference is mostly volume. I suspect most use with the cup away from the load for less herb? No, I don't ever use screens in Ascent. I use top shelf bud mostly, ground medium to fine and well cured. Nothing gets past the four holes worth worrying about. Done that way the load gets...
  3. OF

    Arizer Solo

    Yes, 2.5 is a solid limit, don't try to cheat it. I have a supply that claims 2.25 Amps, it'll run some of my Solos but not others. If the Solo is already hot it seems OK, it's that marginal. And, while it's true some/many reported success with those supplies, some reported problems including...
  4. OF

    Arizer Solo

    Because it doesn't work? In the few tenths of a volt past 8.9 Solos start to flash and beep in the 'noman's land' between there and about 10.1 Volts and above (up to 15 or so) where Solo Charges normally. Don't go above 8.9....... Charging happens above 10.1 and under 15 typically. Less than...
  5. OF

    Arizer Solo

    Although I don't hold much hope, if it was mine I'd sure try to run it in PA mode. Anything from 7 to 9 Volts (7.0 to 8.9) should work if it has more than 2.5 Amps available. Positive in the center, but I guess you know that....... Good luck. OF
  6. OF

    Arizer Solo

    Bummer. I assume, since you didn't say otherwise, that the unit works but won't charge? If it's the old style, which you could run in PA mode with a special supply, there's a slight chance that feature survived. I'd be surprised, but it could happen. The charge and PA functions share key...
  7. OF

    Arizer Solo

    Evidently not. Have you tried a gram and a half? OF
  8. OF

    Vapman

    It'll be portable, as soon as we put the handles on it....... OF
  9. OF

    Vapman

    Depending on how you rig it I guess, but IMO the right way is to make sure it can't happen in the first place. Either with a shutter or by completely enclosing the 'bright part'. The last idea I had on it called for a metal block to heat (rather than the vape directly) and you would draw heat...
  10. OF

    Vapman

    Yep, it's been kicked around a couple of times, like here: http://fuckcombustion.com/threads/vapman.94/page-179#post-846328 http://fuckcombustion.com/threads/vapman.94/page-179#post-846447 http://fuckcombustion.com/threads/vapman.94/page-179#post-846461 I poked around with it some, the lens I...
  11. OF

    Vapman

    Not that one, but the idea is common enough. I have a couple I've picked up over time, at least one from Amazon like: http://www.amazon.com/gp/product/B00XVO5S2W?keywords=solar%20power%20bank&qid=1457710530&ref_=sr_1_3&sr=8-3...
  12. OF

    Vapman

    Agreed, holding a leash can command a LOT of attention sometimes. Sinclue (dog walking fool he is.....) passed on a great recommendation from Randy at PIU for such duty, the Summit. Darn near ideal IMO. You might want to check it out? You load the bowl (under the magnetic cover) and put it...
  13. OF

    Arizer Solo

    Sounds like the classic cable failure, right where it enters the plug, where the end of the strain relief is. That's where my money is anyway. OF
  14. OF

    The Arizer Air

    Or charge it fully and immediately use it for a session before putting it away at about 80% charge? OF
  15. OF

    The Arizer Air

    I've already said I don't think it's a good idea to 'use why charging' and why. My opinion there hasn't changed.......IT'S A BAD IDEA, DON'T DO IT. Charge it or use it, but not at the same time, if protecting battery life is important to you. OF
  16. OF

    The Arizer Air

    http://fuckcombustion.com/threads/the-arizer-air.16415/page-325#post-910657 http://fuckcombustion.com/threads/arizer-solo.3833/page-1445#post-923989 Your call, of course, it's yours. But if you check that reference above you'll find that 'leaving it plugged into the charger so it's always...
  17. OF

    The Arizer Air

    Not true in general or the more important specific case of a discharged battery getting 'hammered' into cutoff over and over. In the general case, the battery charges part of the time (heating) and discharges part of the time (when the heater comes on, heating even more). Total heat buildup is...
  18. OF

    Ascent Vaporizer by DaVinci

    Yes, I think most of us find a spacer in the bottom to be an advantage, most 'cup down' (?) but both have their fans/advantages. It can be a useful reservoir of heat. And load size reduction. I can see how breaking a spacer could make a guy a bit shy about trying again, but IMO it's worth...
  19. OF

    Ascent Vaporizer by DaVinci

    You need to understand, or at least deal with, how the Ascent works. It builds up heat between hits, and can drop a LOT (like 100F) in a hard hit. To improve your yield: Cure and grind well, keep it dry, ground and well packed Give it time to recover between hits, try a minute or more Use...
  20. OF

    FlowerMate Vapormax V/V5.0/V5.0S/V5 Pro

    Yep, although I guess it could be amphibious I did in fact mean amorphous, something entirely different. Disordered, which is the important part. The difference between chimney soot and diamond? Thanks for the correction. I'm not sure it's exactly useless, but sure not earth shaking. I...
Top Bottom