Search results

Claisen.

I prefer the look on someone's face when I tell them how LITTLE I spent on a piece rather than how MUCH I spent.:brow:

Does the intake of your bubbler sit at an angle or is it straight up and down.?

:2c: Here. My DO20 is nearly flawless. There are some tiny bubbles in the bridge to the MP and any 18mm male rocks slightly in the Dewaar joint. There is also a slight chip in one slit. All that said it works perfectly. When I watch it bubble it seems that the firing goes around the perc in...

That looks like a good one. Yes it seems an adaptor would be needed.

Thanks got it!

I have used a paper clip in a pinch but I would be careful. I have found some have a clear coat of some kind that flakes off when you bend it.

How do you rename a link? http://www.shop.carbonglasstech.com/ LHS

Inside diameter of the adaptor is about 9mm (3/8"). The rod itself is about 3.5mm. So there is nearly 3mm clearance around the glass. This is not a driver yet. Kinda like proof of concept. I saw pics of the DBV oil kit and thought " why can't I use that nail...?)." They sell it separately...

Using the Hammer top and a Ti nail accessory ($20) from the SSV and some adaptors that I got from oregonglassblower on ioffer. Not the vid you were looking for but it is just another possibility...

You are absolutely right. Yield can be fickle for sure. Believe me, I'm not complaining. As for the other variables, can't grow my own anymore, so I can't be sure of pedigree of strain. I can't be sure of anything in this non-MJ state. I get what's available and the name is whatever my...

It may scratch if you try too hard but glass does not scratch easily. I have used tools like this to stir the herb in my W9Tech Bender (glass chamber vape). I have not seen any scratches yet.

Here's some Purple Sour nug run. 9g in and 2.7 out. Seems like a really high yield. No residue, so I'm not complaining.

I think a stainless steel dental pick ( at hardware stores) or maybe small stainless manicure/pedicure tools (at pharmacy) would work well. It it not as if you will have torch-like heat. You may also look into clay modeling tools from a craft store. Ebay is not all bad. I bought a glass pad...

It's hard to tell from the pics but it really does look like the slits do not go all the way through the perc. Especially after looking at the vid.! That's a real bummer. Be the squeaky wheel!

Agggghhh love it! I need the female vape adaptors and eyeballs.:clap:

If you are not gonna heat it after you cap it (only reason not to need the dabber version. It gets hot.) To experiment with carbing maybe a shot glass or tiny Pyrex or ceramic sauce cup. Something you may already have in the kitchen. If you do want to heat while capped definitely a Ti...

My experience was the same. My tracking for the 186 shows the same. I may have been the first to order the 186. ( shows I ordered 5/8 20:15). It seemed to me like 8:00am EST -ish that I ordered.

I think the intent was good but the methods leave much to be desired. Those archaic methods were a means to an end. There have been many to take Rick's "ball" and run with it. I posted this on another thread but it is relevant here as well. http://www.badkatscannapharm.com/ There is a wealth...

From what I understand, the stock batteries cannot supply the current that the Herc demands. Voltage is the same but it is all about the amount of Amp draw. I use the Herc with 2x AW IMR 18650 with the SS kit (Herc-saber), or The Core. I have 2x AW IMR 18350's on the to be able to use the...