Exactly this for me. Multiple hits at low temp turning the dial up a bit and all the vapor gets exhausted for me. Even if I turn it up a bunch at the end. There is often nothing left.
Repacking a dynavap in your use case is easy, fast and fun. You like hitting the joint, going back inside, and then a bit later, relighting it and hitting it again. With a dynavap you would hit it a couple of times dump out the bowl, go inside and do something, and then pop back out pack it in 5...
Any chance stunner heads are coming back in stock @tinctorus ? I read through this whole thread and wow. I’m excited to try one even though I’d be considered a microdoser by most users. Might be great to pass around. It would be like passing a cigar maybe… @TigoleBitties your descriptions have...
I often weigh out amount in the 0.035 range. I’d go with a capsule for your current POTV device or get a Dynavap halfbowl setup. Easiest would be the B which is already a half bowl. Lightly filled with fluffy fresh ground botanicals would be about 0.025. I can usually feel the clic. Cost is very...
Type 1 is basically all THC(a). Type 2 is a blend of THC(a) and other Canabinoids like CBD(a) or CBC, etc. usually the THC is 4 - 14 % or so in type 2, so usually you need to consume a little more if you are used to 24% THC bud. Type 3 is CBD flower, so less than like 1% THC(a). Sometimes people...
My favorite are the type 2 flowers, which are easy to get via the THCa vendors. Straight up they are nice and balanced; mix in a little with some type 1 and they are much more complex and interesting than type 1 alone. I think it is the other cannabiniods that are present that enrich the...
I love this thread as I am in about the same place as the OP. I’m running a TM2 and have been eyeing the phase 3 ZX. I use small amounts mostly around the weekends and share with my partner almost all of the time. We also are quite mobile around the house partaking in the hot tub, on the couch...
I was also finding that the later hits on my TM2 were harsh and something that correlated with higher temps…but then I added a finer mesh screen and worked in some ball cooling and harshness is all gone. I was mobilizing but of tricombs in the pure convection wind stream…could even see them. Now...
It’s not surprising that the top two picks are 0.05 and 0.1. A dynavap basically holds 0.1 or 0.05 (for the B or half bowl) and for me at least stuffing more than 0.13 into a TM2 stem feels like it might lose out on some efficiency. I’d rather come back for more in another sesh.
I’ve tried to just dribble it in and that does work but not a well as getting a fine coating across all of the balls. Also it is just too easy to pull out the herb screen and rinse with water then blow out all the excess. There is a bit of flavor loss as you might expect, but not that much and I...