Recent content by Katysax

One vaporizer is just not going to be everything. Design is always a tradeoff. I've tried a lot of vaporizers, and while it isn't discrete I believe the Arizer Solo is the best all around for herb and it is relatively inexpensive. There are enough aftermarket options for stems that it is...

I've got a 2.4 ohm cartridge that just won't get started. I put some CO2 wax in there that is definitely full melt. I've seen it melt to nothing. I warmed the cartridge thoroughly with a hair dryer and loaded about .6 wax. It didn't melt easily so I ended up using a flame to get it fully...

I'm a little mystified by the Hercules. I took it in yesterday to Delta 9 and after they showed me how to assemble it and gave me new heads - the vapor was awesome. I took it home and tested it and it worked great. Then I pulled it out in the evening and all I got was wispy. Nothing I did...

The customer service has really been great. I had bought my Persei from a non official vendor. Delta 9 was very nice to let me buy a warranty and replace my tops. They've also been quite helpful.

Delta 9 must be replacing a lot of blown tops. I blew both my tops trying to use the Hercules so I took them over to Delta 9 this morning. They replaced both tops and also the melted down bottom coil. They showed me why I was having trouble with the Hercules. The bottom line is that is has...

An Ed's stem on my Arizer Solo cools the vapor dramatically while still allowing good hits.

I actually think the cheap pens like the MicroG or Cloud work pretty well and are easy to use. The problem is that you have to keep loading. The other problem is that it is easy to get burnt stuff. If you want to go a bit more upscale you can add one of those chambered globe dabbers. I...

I probably won't do it. I don't have any deionized water handy. I could make some, but that's another pain in the neck.

I read the manual - which is why I knew it said to do the sterilization first. It seems odd and inconvenient to have to sterilize it right off. That's why I asked if it really is necessary.

I got my Hercules. Do I really need to disassemble and sterilize before using it?

I found this forum about six weeks ago. This is my fiftieth post. Thanks to this forum I've learned a lot. I'm mostly using an Arizer Solo and Omicron pen. It's kind of cool to live in California and have so much stuff readily available.

I picked up the O-Phos from Delta 9 vapes. It does just fine with the 2.4 carts. I don't think it's all that stealthy though. Currently I'm camping, and while I hadn't thought about it, the O-Phos or Omicron Light is a better fit for this trip than the Omicron or Perseus. I can just recharge...

It's not near the Delta 9 Dispensary - it's Delta 9 Vapes in Van Nuys. The address and phone number is on the web site. Call and check if it is OK - they told me to just come in. It's not a store. They do have a cabinet with a few items, and they will demo stuff to some extent (no they won't...

So I have a multimeter - I use it to check battery voltage. Where do I put the leads on the cartridge to test for continuity?

The Omicron loading tool will get very hot with a hair dryer. It will definitely melt wax. It also helps to warm the cartridge without damaging it which a flame can do. I tend to use a flame at the end to finish the loading, but the hair dryer unquestionably turns the wax to liquid. Delta...