Tracker on how NJ legislators or leaning:
https://www.nj.com/marijuana/2019/03/heres-how-your-nj-lawmaker-is-leaning-on-legalizing-weed-click-our-exclusive-tracker.html
We are really close to getting this done:
https://www.insidernj.com/right-now-sweeney-short-votes-senate-marijuana-legalization/
but we need everyone living in NJ to contact their local representatives/state senators and urge them to vote yes on the legalization bills. If you don't have the...
I have the same mod and never had much luck with the FCShare DNA settings. In the end I loaded a bunch of different TCR settings and payed around with it until I was happy with the vapor. I think you can also adjust the curves on the material files, but from what I could tell they are all...
I have found that the way I pack the stem has a major impact on the vapor. For me I pack the stem as loose as possible without tamping it down at all. The more a tamp down the stem the less vapor I get.
So far the coils are working great. Nice clean thick vapor production with no glow.
Thanks. Right now I am liking the 7.5 wrapped coils and my wife is getting sick of me changing things on the vape. Next time I make coils I will definitely give your method a try.
Thanks, I had seen that, but $30 seemed a bit pricey for a screen making tool. My method is a little more work, but I was able to do it with materials I already had on hand.
I wrapped the coil on a hex key, then mounted them to the deck andand trim the extra wire. Finally I put a smaller hex keybthroukeone of the coils and used a flatvhead screw driver to fan them out. Rinse and repeat.
So I tried making 10.5 wrap coils from my SS 316L 20 gauge wire but it was a bust. My DNA mod gave me the dreaded OFF message despite everything I tried. 7.5 wrap coils fanned out seem to work perfectly. They worked so well that I was only able to get 3 test draws off it before I had to sit...
Turns out it was the coils. I had tried SS316L 20 AWG 10.5 wraps which gave me the error. When I tried 7.5 wraps I was able to fan it out more, and get no error.
I've been trying out new coils in my StemPod and my Wismec DNA 250 gives me the off message occasionally. I can't seem to figure out the pattern. If I hook it up to escribe and run the monitor it acts like it's in TC but the screen just reads off. then sometimes it runs normally. Any ideas?
So I finally got my 20 Gauge SS316L wire and I have been playing around making coils. In supershredderdan's video on changing coils, he recommends fanning out the coils; Is that required or can I use the coils tightly packed. My thinking is that if I leave them tightly packed on can probably fit...