Recent content by DorianGray

Wow, this feels like volcano vapor through water, plus much denser. I’m loving it . A thorough stir after every draw produces some nice clouds 😎

Hello friends, I just got my evo and I’m trying to dial in the temps and draw technique. im liking the 2 o’clock position. If it’s whistling I’m drawing to hard? I begin with a slow draw and increase slowly?

Thanks , I used vaporizers.ca and was able to get expedited shipping!!

Hello forum friends. I want to purchase the evo but apparently there are big shipping delays at vape exhale. Does anyone have a different source?

Hello gents, is it possible to get a NonaVong wihout a airway hole in it and no mouthpiece? I'm having a hard time put together that configuration on the website. Please help!

Hello All, I'm thinking about my next vapcap purchase. Do any of the nano vongs fit my 18mm d-020 bubbler without the need for a reducer? Also, does wood on glass create as good of a seal as wood on rubber? I've been using the rubber adapter from ratchet that I had bought for my crafty...

For people that use the hemp fiber as a filter in the chamber, what do you do with it when it's drity, throw it away? how long does it last? Also, are people using the hemp fiber filter in addition to water filtration or is that overkill?

I appreciate your input. I'm using the WPA. I'm trying to visualize what you're saying. :hmm:

Anyone have a solution to avoid the dark spots in the middle of the load?

I get white walling hits on my first heat cycle, no preheat, no heat past the click. What I do is: -make sure the material is dry -use a dual flame torch -apply the torches on the N, perpendicular to the cap -block the carb with tape Voila!

@biohacker does the solo 2 require stirring?

I find I always have to stir or at least dump and reload with the solo. That's why I've only used it a few times, I despise stirring.

nice, I use @Ratchett 's silicone water piece attachment that I had originally bought for my crafty. It's a little bigger than yours, sits much deeper in the vapcap, and creates a fantastic 18mm seal to my d-020 bubbler. -With this attachment -Closed carb with tape -Heating with a 2 torch...

I received my 2 magnets today. Unfortunately, they are both useless. I purchased this one: Dimensions: 3/4" dia. x 3/8" thick Tolerances: ±0.004" x ±0.004" Material: NdFeB, Grade N42 Plating/Coating: Ni-Cu-Ni (Nickel) Magnetization Direction: Diametrical Weight: 0.72 oz. (20.4 g) Pull...

I have been using a single, double, triple, and quad. Lately I've been getting best results with the double torch with the torches aimed across the cap focused on the N, as opposed to the torches aimed along the letters (going from up down).