Recent content by condition

I have a SS CU for my crafty+. It tastes better than the plastic, and the vapor is cooler. However, it gets really hot after around 5 minutes, and it could damage the plastic threads of the main unit. It didn't happen to me, because I was careful when using it, as my Mighty OG slowly lost all...

The curved tweezers should act like a hook, if it is thin enough it will pass through the openings of the CCD. You can also heat the cap first and hold it with a magnet.

Philips air purifiers work very well with smoke and vapor. However, a smell may still be present if doors are closed and there is no natural ventilation, in this case a candle will diminish it.

Allergy sufferer here. Are these symptoms new to you? Before vaping you used to smoke same herbs, without coughing? In Europe we had very mild, humid winter and pollen is revenging now. Tough allergy season

The rubber button fail is unacceptable. Up and down buttons are there to be pressed and it sounds like a joke, that a button that is there to be pressed fail like this. The orange up and down buttons stand out, like inviting you to press them.

With curved tweezers.

In my opinion, instead of the USA get the Anvil's WPA. It seems to me unnecessary complicated to attach the thermocore to the USA and the USA to DV's glass adapter, in order to use the Anvil with glass. Also too much space before the glass. If there is available, also get a small cylinder made...

Then you may want to expand towards caps and get the helix tip with a perforated cap and an armored cap, or a low temp cap - just a thought. I also have previous models but at the moment I use a perforated cap with helix tip with glass and a simrell stem with 9 fin tip and low temp cap. No...

It depends on whether you have another DV and on the intended use, which cap would you use, which stem, way of heating and so on.

Thank you, I have many torches, but you mean to order the full case with different compartments instead of the egg? I am not sure if I need it. BTW I tried contacting a rep through the (inviting) chat button, but have not received a reply. I may proceed anyway. @Dr. G ok I wrote above before...

Thanks, do mean the long Vapman borosilicate glass mouthpiece?

I will, thanks. So this is my cart. Is there a comment or something you would like to add?

I am ready to get a vapman for 4/20. I was between this or the sticky brick. Decided to order vapman as from what I read is great for microdosing and traditional hash. Also the heating station is a plus and I think to add it to my cart. Do I have to leave a note to set it up for higher temps in...

The ronxs torch that Anvil's maker initially recommended, fires the thinest flame of all similar size torches, but the flame slowly reduces. Approximately 30 seconds later it almost loses 30% of the flame power. The Blazer cannot fire so small and thin flame but it keeps it steady during these...

Big fan of WPA here. Simple and effective. Really shines with dry glass. I have both 14 & 18 sizes.