• We are experiencing temporary outages. Keep trying, it does recover. We hope to rectify this as soon as possible.

Recent content by Brenyo

  1. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    It’s either what was quoted above, or more likely there is a burr at the second notch within the housing. Try to move the pointer with a pin manually to the end once, and that might fix it.
  2. Brenyo

    Induction Heater Yllvape IH Power and temperature controlled induction for use with Dynavap

    The sample I have does seem to work with everything. I’ve been testing it for a while now. It works well up to around 70 W, above that, you need to keep an eye on the battery charge level to get the max power. It’s quicker to heat than the wand.
  3. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    Yes, it could be delayed even further, unfortunately. I’m waiting for the reloads and the tool case.
  4. Brenyo

    MadHeaters Shipping Thread

    Sorry for the delay, I’m still catching up. It should be on the way tomorrow or Monday with plenty of extras.
  5. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    T2 has a slightly smaller ball chamber. The sleeve and cap height is 1mm shorter. The difference is about £11 if I remember correctly.
  6. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    ~90F less or 40-50C on the V2 compared to V1 glass adapter
  7. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    Sorry for the inconvenience, please try to unscrew the indicator housing and check if the outer end of the spring is in it’s place within the side wall.
  8. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    No, I think there will be a small batch initially to make sure that there won’t be more QC issues from the factory. I would guess so, if they order it then yes.
  9. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    It will be available during the pre-order
  10. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    No unfortunately, but it will be available at VDN. I’ve uploaded some new pictures to the website.
  11. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    It does, all good there. Yes You might have the adapter set too deep? Not sure what else it could be.
  12. Brenyo

    The Tempest by Mad Heaters & Phatpiggie

    Yes, just undo the screw and remove the whole indicator housing. You don’t have to take it apart any further, just check if the end of the spring is in it’s place. There is a video at the bottom of the manual of the v1, on the V2 it’s much easier to put the outer end in place.
Top Bottom