Recent content by Allbusinessjr

Am I SOL if I can’t get the update to take on the web app? The device connects and shows me serial/firmware (1.07), but never makes progress on the firmware update stage 1.

Apparently a lot of button issues. Is the button supposed to be fixed or does it move around a bit? Mine has a lot of side to side movement but it does not feel like it’s at risk of falling off.

I ordered in early September and my button is virtually identical. It has some play and often leans to one side or the other but it’s a MASSIVE improvement over my button on the 7, which had very little clicking action and was prone to sticking. Fortunately, this button is very responsive and...

Same happened to mine and it also fixed itself. Marc got back to me and recommended using tweezers to grip and rotate the button in the event that it happens again.

Thanks. These things happen. I’ve reached out to Marc.

so my firewood 7 button just became stuck and will no longer respond to presses. I assume this will require a repair back at the “factory,” but if anyone else has experienced this and managed to fix the button, I’d love to hear about what you did to get it back up and running.

Ya, I think the better way to describe it is that one side of the button is lower/harder to press. Might need to send CS an email.

I know it’s new toy OCD, but does anyone else have a unit with a wobbly button that doesn’t want to sit flush? Not the biggest deal, but seems like my thumb is always brushing against the edge of the button.

My third stealth’s latch chipped again. Only a matter of time until full failure. Disappointing, as this is clearly a design defect that takes away from an otherwise awesome device. is it confirmed that the latch issue is less prevalent on other colors? A few months ago, I’d noticed that some...

So I just received a replacement unit for chipping finish and I’ve noticed that my crucible tray no longer has a stop-click when fully opening the tray. The unit with the defective finish had a tray that would click into a fully opened position, but my replacement unit does not exhibit this...