Recent content by A7XFREAK674

If you turn the dial up to 10 on the 2 it allows all the available heat, I think intended for concentrates but you can absolutely play around with it.

Yes it is

By the end of the month is what I've heard

Had a little fun with the Tinymight and the Tinymight 2 earlier, figured I'd share.

Can confirm on the titanium stem. Also I can finally mention I've had one in my possession for a couple weeks and it's been wonderful. Same great performance but less char rings for sure. Definitely loving the battery cap and new tool for stirring or adjusting the cooling unit. I'll try to...

Vibrating module is still in there

Just gave it a go. Not great at all. It actually is an improvement over the original but that's still not saying much. There's a new technique where you heat the x cutout as you inhale. No indicator this time just go by feel. My first couple hits weren't that bad but the bud was barely vaped. I...

Interested as well!

Got one in the mail today, haven't tested it out yet though. I'll report back but I don't have the highest hopes based on the performance of the original model.

I have an old post on my reddit showing the Lotus with a WPA on a beaker bong. Here's the link (sorry don't have the original video to post another way)

Mine just arrived yesterday, I have to say I am pleasantly surprised to this point. Cool, enjoyable vapor. Definitely satisfying to use. I'm understanding the Tinymight comparisons but definitely need some time to put it through its paces before making any statements on that comparison one way...

Just wanted to pop in and say I managed to get a V3 Pro direct from TopGreen and it arrived yesterday. I have to say that so far my expectations of a 100 dollar range full convection vape have been blown out of the water. Sure it doesn't hit as hard as some other convection vapes that cost...

Got one sent over from Boundless today. The teal model. I've only had 2 sessions but I am impressed at the volume of vapor produced at the second heat setting. The device does get hot (like an iq2) during back to back sessions but I was never worried about getting burnt. Not generally a...

Hey as some of you may know I got my hands on one of the early 3d concept prints for the jetpack (with the provision I provide the stem and did some.. well a lot of sanding to get everything to fit.) I've been enjoying the learning curve as haven't had the chance to use a sticky brick prior to...

I'm open to any help! I'm only trying to contribute here so sorry about the link. What is the preferred service?