Search results

I have a Ronyx triple flame that I like a lot because it’s compact and upright, but still powerful. In my use, I have found that the faster you get to click the more convection, heat, and better flavor extraction you get. Depending on the temperature outside, I can get to a load temp click in...

The stem will fit most 14mm joints - it just slides in until the stem is wide enough to catch it. I suppose some joints may not have enough depth, but in most cases, it works - you don't need the WPA. There's a video from Table Top Bongs that shows it nicely with a globe. I have used the native...

I stumbled on a neat trick today while cleaning - for those that struggle getting the 2.0 into the half bowl setting: Take off the mouthpiece and use it (o-ring side down) to press the screen slowly into the bowl. The diameter of that side of the mouthpiece is almost the same as the bowl, so it...

Look down the stem with the mouthpiece up and the bowl side down. Assuming you aren’t already doing that, you can see the airflow holes better that way.

Thanks, that's good info - .1g -.2g is a good dosage for me.

I’ve been using CBD flower to dial in my technique. I’m a newbie to brick vapes, so it’s been crucial to actually remembering what works. A question for the knowledgeable: is the Nova bowl bigger than other bricks? It seems like it would take at least .2g to cover the entire screen as...

Mine has a pretty faint click in that you need to be listening for it. I can feel it too, like a light haptic feedback. I wish it were louder, but it’s not a deal breaker for me. The cool down click is much more audible.

Thanks! It's crazy, I haven't consumed by combustion in about 5 years, and the stench brought back memories of what my life used to smell like. I'll power through!

I finally did it and combusted in my Fusion (2.0). The thing stinks, and even after a pretty thorough cleaning (q-tipping and wiping, not soaking), it still has that combustion reek. What's the best way to clean after combustion? Do I need to soak for a long time in iso (trying not to have to...

solid advice The stock short woody has four holes around the stem for cooling as well.

Is that a Tempest on the right? How does it compare to the Dani?

You definitely need the screen or you'll inhale the contents of your bowl.

I just came back here to say that as well. I took it apart to clean last night and popped out the screen. There's a little notch to hold it at the halfway, or it can be pushed down. It's a bit tough to get it back at that halfway mark, though. Despite my best efforts, I'm sort of at a 2/3 bowl...

After comparing the bowl size with my HR Rogue, I just realized that the screen is set to half bowl size. It's pretty amazing because I've been using it all weekend, and it hits hard for about half the size bowl I'm used to loading. To use the whole bowl, do you just remove the screen, or does...

Anybody using the 2.0 version know if it's still recommended to leave a small gap when putting on the cover?