There is a new variant. The Hybrid, which is made of Titanium also has gem cut ruby's in the head. So now it's the original Stainless and Titanium solid cores in addition to the new Hybrid.
Seems a bit long to be honest. I gravitate more towards the inductor now but I don't remember the wand taking more than around 45-50 seconds. Might want to try some different positioning.
I guess I should clarify that this was with the smaller sized matrix (TA1 and TA2) so maybe if you are...
I spoke to the owner of the company over the weekend and it sounds like what you're describing is just a banger experience.
I spoke to him about the price point and said by the time you get a wand you're over $300 for this setup and at that point you are competing with pretty established...
Yes I believe @phattpiggie has a handful of units he was holding in the UK that he intended to send over. More of the Cherry/Birch wood units. Otherwise I'd reach out to him directly here if you are interested in something special.
Yeah it will hit a point that you need to have something in the coil for it to heat and go any higher.
@ColdAssistant it's going to depend somewhat on your PID but I am guessing you can probably run it even close to 500 and still have enough heat. Personally I like keeping it a little...
Yeah it's been a little while since I've been on the torch but I don't think I ever did it more than 30 seconds. It's pretty forgiving and if you pay attention to the vapor you should have a pretty good indication if you're riding a line too much or if you are ready to rip freely. I have been...
He may cover it. You just need to ask him.
To be clear these are all brand new and have been opened only to perform a necessary firmware update. They don't have Ruby (can be added later) but are all out of the last batch and include the updated cooling unit.
It's not uncommon for...
Perhaps the navigation bar at the top of the site would be helpful. CFH is under vaporizers.
As for shipping, we typically notate if shipping Is NOT available for international orders. We have no such notation on this because I think we can make this work in most circumstances. We look...
Yes that's right we will replace any of these fitment issues. There were some out of the first batch and I sent them a cooling unit after that so they could have better tolerance testing... But once again if you got it from us just holler and we'll square you up!