Asked hubby about this
Distribution and suspension are the hardest things to achieve infusing oil and simple syrup/honey
He uses lecithin with coconut/mct oil for a fat infusion
Uses gums to bind the rso to the sugar water (his words)
For the honey he suggested infusing single servings instead...
Can anybody help?
I was cleaning up and a piece of bubble wrap got on the cylinder and sic dish on the B2
Unsure how to clean it!
I'm going to search the threads but would like to use it now
If its not too much of bother
Edit:
Does cannabis hardware do pre orders for sold out items?
Switched from a Santa Cruz shredder to a stainless steel BCG
The SC teeth would get clogged with material making it hard to clean if one has hand issues
No complaints about the BCG after a couple of months
Only build up is on the surface of the disc around the holes
Minor complaint and more...
Agree with the above post
About 5% thc-a, Psychedelic Sam had a sample tested, well known home extraction guru (R.I.P.)
We have a jar of abv tincture that is waiting to be infused into something or reduced to concentrate
Hubby did a large extraction Of ABV
Required a lot of ethanol as the material has little water and oil left and is very dry
He learned his craft from Psychedelic Sam (RIP)
Sam had some testing done and he reported that not much was in there but there was 5% THC-A
This was one batch so take it...
Use thick glass ash catcher and water pipe
Hot tap water pre rinse for any leaf/bud material
Its Boro so boiling water is used to rinse the gunk off like the waxes and waste from trates
If there is a bad film some 99% iso or high proof ethanol is used to remove most of the film
Boiling water...
Bit of a newbie
Was getting fluctuations and the EEEEE
Cleaned the post as some debris had collected
No problems since
How long do coils last?
Had mine for six months but hope it is not on its way out
Bought back ups
Got all three plates
The fine grind works great in the CH glass bowls
Mine came yesterday
Lots of sticky from the festival as well as some fungi to experiment with this vaca
Awesome weekend!:rofl:
That was the expectation for switching to 4mm and lowering the temp
Did not experiment with temps which was a mistake
My experience was a muddled flavor at the temp I was using
To many variables including the flower to pinpoint any one reason for lack of flavor
Dropped quite a bit of...
I have stories....
Used the concentrate dish on top and made a mess of the rubies
There are a lot of critics of the flower pot but the B-2 does double deckers that will flatten you instantly
The clean up sucks
Used a glass baking dish lined with a Terry cloth towel and poured 99% iso over the...
Thought about removing the nut but hot rubies escaping made me think twice
If memory serves me, the video that you watch for assembly recommended filling up the "neck" of the chamber
Lots of use of the term heat retention and recovery phase
Removing the rubies will get a try as a decision on a...
Did read some older posts but that just made me have more questions
Things change quickly and new equipment comes out every week
Its too much
Figured I would do small changes to what I have but the big issue I know that needs change is the airflow
Did 4mm but the difference in flavor was not...
Hi, new to the site
Currently using a B-2
The air flow is restricted as I draw through an ash catcher into a water pipe
Any thoughts on the F22?
Is it better and does an injector do a better job?