Recent content by SparkyMcBowl

My switch died recently and I had to switch out the driver. It's a custom piece, built by Pipes, and not something you can get elsewhere.

Here's V2

Similar, doesn't look as sharp.

Right here.

https://newfuckcombustion.com/index.php?threads/splinter-v-z.95/post-8225

My entry for the contest. This was one of the first times I got interested in DNA mods. https://fuckcombustion.com/threads/splinter-z-by-rbt.34076/post-1308853

I think the store is closed at the present. Milaana 3 is a solid vape to start on from RBT. You won't have to deal with a mod like you would with the Splinter or the Splinter Z. No need to concern yourself with firmware and Ohm's Law if you can avoid it.

Yeah, that's what I'm afraid is the case, even though the soldering looks solid. I'm going to put it away until I hear back from Ralph. Really disappointing.

Are you referring to the "PWR" setting on the main page? I've changed that to 70w. The temperture still reads from 600-700F with no vapor produced.

The month old Gen3 Dual is getting 0.324. Two other mods (Cuboid 200, P80). wouldn't recognize it was there without putting a heat sink on first, then would both read 0.26x-0.28x. With three otherwise perfectly functional mods all having problems, I'm certain the problem is with the one device...

@funkyjunky Think you could take a swing at my problem? I was actually just writing you a message about it.

Then it's going to have to go back to Ralph, because it doesn't work set to 0.191. Adjusting the temp won't do anything if it's reading 600-800; it's set to 380F

I've tried a few mods, this is definitely a problem with the TuboX.

No, because when I set it up according to the sticker and manual, the display temp ranged from 600-800 and no vapor was produced. The sticker said 0.191, cold read was 0.324, I've got it adjusted down to 0.265 for the moment but not happy yet.

My TuboX came in last week. The resistance was wildly off, I'm still trying to get it dialed in. Time for another try.