Recent content by jmartis004

I have a PD and use the tubing with the unit occasionally. What I did was take the sleeve that fits the CRZ and slide it into the tubing. The tubing can then slip over the heat port and allow no air out. The sleeve being inside the tubing allows the vapor tube to slide in easily and remain snug...

Just an update, took apart my purple days myrtle since it had been poorly heating and loose. Took the heat exchanger out and disassembled for alcohol wash (pretty dirty), removed resistor to clean skirt walls, and wired the cord directly to the resistor, as my plug is now loose. If anyone knows...

wow perfect. Thanks. On a related note, this thread is probably not appropriate for a teardown with pictures? I can start a new one. Regardless, I do have some issues with slight charring in the units. I got some pictures

Well I doubt I can find out when I open it by the plug itself but we will see. I was hoping the pandora builders or maybe someone who knew tom better would have a mfg or even a specific part number on that. Of course close enough will work but this plug must be trackable to somewhere. At worst...

I am looking for the jack and not the plug. As in I want the PN for the female power connector that powers the PD. Mine will no longer grab the power plugs tightly and I want to switch it out while I am rebuilding mine. However, I would rather replace it with the exact same part so the hole will...

Guys, now that the PD is no longer in warranty and repairs might be needed, can we get part numbers on all the internals possible? Specifically I was looking for the female power jack. Any one know a part number or mfg on this? Id love to replace mine.