Recent content by EddIW

Here's a pic from the little teardown he did

About .3g give or take 0.05

TWAX hit with the taroma XL. This thing just blows everything else out of the water easily, its unfair.

Some Taroma XL action for the thread

I think tweezers would be the best bet, but I've never been in this situation. Good luck, hope it starts working once you get it off.

You have pushed the screen onto the heater, that screen in supposed to be held in place above the heater by a metal ring. I'm uncertain if just removing the screen will fix the ussie, but that is the cause.

Just found this. However my P80 that I have glows at max temp in the dark, it was also broken and fixed by lamart at one point so he sent it calibrated to glow at max temp. Also recently my tetra dual for some reason lost performance, to the point I needed to change the coil number from .207 to...

Got my T-bucket up and running recently. Decided to make a little video as there aren’t many usage videos I could find. This was at 690. Love it so much. T-bucket + baller = endgame.

In my experience the carb cap is a necessity for the weedeater to get the hits I wanted with my draw speed.

Might be bit of a long shot but can anyone confirm that the "silver plug" version of this flat coil will work with the old newvape PID pictured below. Just got my T-bucket today but ordered a new flat coil that doesn't work with my controller so had to order the one above. Also the above coil...

Might be bit of a long shot but can anyone confirm that the "silver plug" version of this flat coil will work with the old newvape PID pictured below. Just got my T-bucket today but ordered a new flat coil that doesn't work with my controller so had to order the one above. Also the above coil...

No cap needed with baller head, unless also doing a dab.

Baller head filled with 3mm rubies + .3g flower. Didn't think it got better than a capped VROD but the baller is something else imo.

Unfortunately my bowle is experiencing the issue of not recognising pulls and just cutting the heater off after a few seconds(both push and hold methods). Not the first to report this issue in the thread so don't know what to think about that. Waiting for response from vapefiend about warranty...

Here you go https://fuckcombustion.com/threads/tinymight-vaporizer.44563/post-1571138