Shatter making noob

[J.bonez90]

Hey guys, my gear finally arrived. I've got my extraction tube, filters, 3 gallon vac chamber, 3 Cfm single stage pump, heat mat and an infrared thermometer. I've done the blasting process enough to know what I'm doing there, but some tips and tricks with purging times and temps would be great. My goal is to make some pull and snap type shatter. I've done some research online but everyone seems to have different opinions. Also, does using different material make a different in what temps you should be using, ie between bud runs and shake runs.
Any tips and tricks are appreciated!

Cheers

 

[Puffers]

I set my chamber to like 85-100 degrees depending on the setup. Use hot water to get bulk of the solvent off. Then vac and break a few times as it muffins and comes up to temp. Once it's fairly stable I hold vac for around 24hrs ish. Flipping the slab halfway through. Don't mess with your oil during purge whipping or multiple flips will usually yield wax. Live resin runs and certain strains also have a tendency to auto wax sometimes.