Snicklefritz
New Member
I found this while I was getting gainz for a wireless Electro-FlowerKettle setup which will come together with a CT dual PID over the next few weeks. After choosing the hardware, I was looking for a clean >$100 dock, with a clamp or similar that takes the weight of a 30mm gooseneck coil, the Injector/Diffuser and also hold a corded bowl when not in use + a few other 14/18mm things. From what I can tell there are not many options if you have over 25mm coils and this dual PID.
The cleanest way would be to doing nothing and just use stands but I would prefer an AIO solution. Initially, I wanted to grab a Zenleaf but it is 25mm. CT have a coil-free dock but mentioned on their site that a 30mm coil would only leave a 1mm gap around the housing and is not recommended. The Etsy options won't fit my PID.
Could the iKape/Vape possibly sit atop the controller and become a wireless docking station, pull great shots and amazing clouds?
The knock box is Stainless Steel. The housing is walnut.
My idea would be to:
- run the gooseneck into the knock box on the right and stabilize appropriately
- use the Corded bowl with the longer 20mm handle on the left
- drill a few of holes into the remaining storage space, top right, to fit 10-18mm attachments if necessary
aliexpress.com
vgoodiez.com
Here are some more nice looking SS heat-proof caffeine stations you could rework to become cannabis docking stations. The holes for the largest coffee parts are 50-70mm. A 30mm coil in that gap and an Electro Kettle will do a lot more than the 80mg of caffeine from this Bezzera ever could.
The cleanest way would be to doing nothing and just use stands but I would prefer an AIO solution. Initially, I wanted to grab a Zenleaf but it is 25mm. CT have a coil-free dock but mentioned on their site that a 30mm coil would only leave a 1mm gap around the housing and is not recommended. The Etsy options won't fit my PID.
Could the iKape/Vape possibly sit atop the controller and become a wireless docking station, pull great shots and amazing clouds?
The knock box is Stainless Steel. The housing is walnut.
My idea would be to:
- run the gooseneck into the knock box on the right and stabilize appropriately
- use the Corded bowl with the longer 20mm handle on the left
- drill a few of holes into the remaining storage space, top right, to fit 10-18mm attachments if necessary
Ikape V3 Espresso Knock Box, Espresso Coffee Organizer Box - Coffee Distributor - AliExpress
Smarter Shopping, Better Living! Aliexpress.com
Dual PID Controller by Crossing Technology (CT DPID)
Basic DUAL PID with 5 PIN XLR Pinout compatible with all coils in our shop! This is the diagram on the right. Coils must match! No returns for coil incompatibility. This has two hard on/off switches to power each PID individually but only has one power cord for convenience! Front Input...
Here are some more nice looking SS heat-proof caffeine stations you could rework to become cannabis docking stations. The holes for the largest coffee parts are 50-70mm. A 30mm coil in that gap and an Electro Kettle will do a lot more than the 80mg of caffeine from this Bezzera ever could.
Last edited: