Cannabis Hardware (formerly NewVape) FlowerPot Twax Vaporizer

Gigsabits53

Well-Known Member
Yes they were. Totally agree now. Haven’t used any of my portables since I got the vrod. Loving the whole experience of using it. Start to finish it’s like a ritual.
The FP has a nice ritualistic experience to it. I love it too! My other vapes get used but not nearly as much since I purchased my VROD.
 
Gigsabits53,
  • Like
Reactions: Summer

disGRUNTled

Well-Known Member
The OG still putting in that work ...........
GHOswYl.jpg

fbJOukM.jpg

6ywe09n.jpg

 

someTooL

Well-Known Member
You may have heard this before...but tried something new to me with the V-Rod.

Glass 18mm bowl, 692 on the dial (yes, I’ve stepped it up lol), 1/2 scoop, no carb cap. Hang the V-Rod and watch the temp. It drops to 688ish without pulling. I wait...till I see it level off and start climbing. Maybe 10 seconds max from the time I put the V-Rod on the glass. Then start my normal routine. Every bowl has been a perfectly cooked load. Best results with flower yet.
 

Ramahs

Fucking Combustion (mostly) Since February 2017
Yes they were. Totally agree now. Haven’t used any of my portables since I got the vrod. Loving the whole experience of using it. Start to finish it’s like a ritual.

Don't get me wrong. My portables get used, but usually just when I'm out and about during the day. When I'm home it's almost always my Flowerpot these days. Though, I like to often use my woodscents log when I'm laying on the couch playing video games. And, I like to keep one of my Woodscents logs on my nightstand. It's great for a couple hits before going to sleep or before getting up in the morning.

But overall, I'm using my Flowerpot 90% of the time when at home these days.
The honeymoon phase sure is long with this one :rofl:
 

Sour Dream

Blue Dream enthusiast
Still in the honeymoon phase at about two weeks, but the vrod has taken over this household.

Wet, dry. Half scoop or full. 595 up to 656. Water piece or j-hook. Flower or concentrates. Master of all!

Ive settled at 656 as my flower (535 concentrates)....with NO CARB CAP (flower). First week was all about capping and turning the Abv dark. All good but second week was the turning point. Started leaving the carb cap off and mastered my inhale speed. I am now getting denser more flavorful tokes. And more times too! Of course, a full scoop will bring even bigger clouds but I get stingy and try to cash it all in one pull so I try to stick to 1/2 scoops.
where exactly is everyone getting that little scoop, i saw one for the pax and had one but it was definitely smaller and useless. That one looks useful
 
Sour Dream,

murf2010

Well-Known Member
I’ve only dabbed twice now. Both were prob way too big, felt like I filled the rig 15 times haha. Anyways, I’m a newb at this dab thing but come to find out, I freakin LOOOVE dabbing in the evening. Perfect wind down and super euphoric. Definitely an indica guy. Been dabbing some cherry pie live sauce and unicorn poop live budder. I never knew cannabis could be this fucking enjoyable.
 

Mr Rooibos

Well-Known Member
Hello everyone. Has anyone had problems with credit card payments recently? I have a fat shopping cart that needs a little help. Many thanks
 
Mr Rooibos,

Dingleb3rry

Well-Known Member
As far as glass upgrades go, it looks like mini mobius, while pretty much perfect, is a no-go for now. Everyone’s sheltering in CA since it’s non essential it’s one guy in the shop, the owner I guess, doing random stuff. Only thing available right now are slides and carb caps, not one single water piece. I’ll just have to be patient .... so I ordered a piece of china glass to hold me over until 2021.

possibly off topic, but maybe someone can chime in: has anyone had an issue with the AUBER unit not fully going into standby?

I did some vrod action this morning, turned the unit off, and went cycling for about an hour. When I came back I was pretty shocked to see it not in standby (red light, screen off) but Instead still on and reading “hot, 103” over and over again. Basically it shut down 99.9% of the way, most likely was totally off, but still appeared to be on and drawing power.

I’m guessing it’s just a fluke?

i turned it on/off again and no issue, but anyone heard of this before?
 
Dingleb3rry,

Chris_CH

Company Rep
Company Rep
As far as glass upgrades go, it looks like mini mobius, while pretty much perfect, is a no-go for now. Everyone’s sheltering in CA since it’s non essential it’s one guy in the shop, the owner I guess, doing random stuff. Only thing available right now are slides and carb caps, not one single water piece. I’ll just have to be patient .... so I ordered a piece of china glass to hold me over until 2021.

possibly off topic, but maybe someone can chime in: has anyone had an issue with the AUBER unit not fully going into standby?

I did some vrod action this morning, turned the unit off, and went cycling for about an hour. When I came back I was pretty shocked to see it not in standby (red light, screen off) but Instead still on and reading “hot, 103” over and over again. Basically it shut down 99.9% of the way, most likely was totally off, but still appeared to be on and drawing power.

I’m guessing it’s just a fluke?

i turned it on/off again and no issue, but anyone heard of this before?

Strange. I have never heard of this. Maybe it was in direct sunlight on a hot day????!!! Otherwise, it was def a fluke.

Thanks. Credit card issue sorted. You guys are seriously fast with the service thing. I’ve just been assisted via email. Thanks again, can’t effing wait 🙌

I got you! :rockon:
 

Dingleb3rry

Well-Known Member
Hey @newvape918 thanks, but definitely not, the pid has seen zero direct sunlight. Stays tucked under my desk in the dark actually :)

I’ll be turning it off after each session for the next few days to sneak a few extra “power downs” to see if it happens again but not terribly worried, although it was quite surprising to discover.

But so far I’ve run it twice and it seems to be powering down into standby as normal. Weird.
 
Dingleb3rry,

bizwaxzion

Enigmatic Cannabist
possibly off topic, but maybe someone can chime in: has anyone had an issue with the AUBER unit not fully going into standby?

I did some vrod action this morning, turned the unit off, and went cycling for about an hour. When I came back I was pretty shocked to see it not in standby (red light, screen off) but Instead still on and reading “hot, 103” over and over again. Basically it shut down 99.9% of the way, most likely was totally off, but still appeared to be on and drawing power.

I’m guessing it’s just a fluke?
If the controller was alternating between 'Hot' and a temp, then that is standby mode (red power button color). The 300-B version defaults to waiting until under 100 to go completely dark (red power button color and blank screen). If the power button is white in color - then it's on and maintaining heat.
 
bizwaxzion,
  • Like
Reactions: Summer

Chris_CH

Company Rep
Company Rep
If the controller was alternating between 'Hot' and a temp, then that is standby mode (red power button color). The 300-B version defaults to waiting until under 100 to go completely dark (red power button color and blank screen). If the power button is white in color - then it's on and maintaining heat.

The heat warning on my Auber was set to 34f when I bought it. You can change it in the settings tho.

But an hour later though?...i mean i guess its possible.
 

Rastakolnikov

Well-Known Member
Yeah the screen stays on until it goes below the programmed warning threshold. Mine was still flashing the next morning because it thought anything above 34f was hot :rofl:
 
Rastakolnikov,

Dingleb3rry

Well-Known Member
Right. Its a new device and I’m far from an expert but I understand that when the coil is 700 degrees as it powers down the screen is on and blinks HOT, temp, HOT temp. When it drops below 100, it clicks into standby, screen off, red light.

what I was saying was, 80 minutes and 21 miles later, the Auber screen should be OFF, standby red light, and coil should be cool.

That was not how the controller was behaving.. It had been blinking 103, HOT, 103 for well over an hour.

I’ve powered it down twice since then, haven’t been able to repeat the issue so far. I think we’ve all had electronics freeze on us before, but this one just caught me off guard. Not terribly worried, but certainly keeping an eye on it for the week.
 

Steel28

Well-Known Member
Should be another week or two for those...AVB can, unfortunately not in the immediate plans.

It seem we are slowly re introducing some accessories. I really do not know to what extent at this point, but i know we are making a batch of the other less popular shovelhead posts right now... so thats progress... right?

Any idea when showelhead will be made? I’m waiting for 14mm glass bowl and showelhead to be back in stock and will place my order!
 
Steel28,
  • Like
Reactions: arb

Zangano Cruel

IG zan.cru (code) zancru (5% NV checkout discount)
Man o man that Cannagar blunt mold looks like it works a treat. Apologies to the strictly vaporists, but I do enjoy having a blunt or joint now and again; Especially with a few mates. Looks like fun. Nice one @NewVape @NewVape710.
Anyone have one? Sorry if this is a bit off thread ✌️
I have one and is a treat.
I’m not a regular smoker, but for a meeting, or with friends, it’s unbeatable.
It packs tight, it’s the circumference and length of a cigarette, if you roll it in a King Size with a filter.
With that center airpath all the way from the top to the bottom, is unbeatable, from when you turn it on till the end.
Stay vaped.
Mantente de la mente!!!
 

murf2010

Well-Known Member
How many of you guys enjoy high and low temp dabs? Been experimenting just under 600 and really enjoy the flavor profile of all the terps as well as a nice slow come up. However the 675 temp dabs are hugely beneficial in terms of pain management and sedation. Both have there place, was just curious if you guys mess around with temps like this?
 
Top Bottom