budbudbud
Well-Known Member
Whenever I want to vape out of a piece with a 18mm male joint, I attach da buddha heater cover to the tubing where it connects to the pipe. Works like a charm 
The only problem I ran into with this setup was the little hole on the heater cover you can see here:
But that was easily fixed by a little piece of tape.
Edit: Just remembered its 18mm not 14, haha sorry guys. I'd change the title but I don't think I can.
The only problem I ran into with this setup was the little hole on the heater cover you can see here:
But that was easily fixed by a little piece of tape.
Edit: Just remembered its 18mm not 14, haha sorry guys. I'd change the title but I don't think I can.