CF2892-C1-E360-4717-B688-544-E60-DBDBCA hosted at ImgBB
Image CF2892-C1-E360-4717-B688-544-E60-DBDBCA hosted in ImgBB
I used pure copper for drinking water lines with a 3/8 tubing.
Tools used
Dremel with a cut off wheel, thinner is better here this is to put slit down the side so it can tighten onto the cap, with the slit cut into it makes a perfect fit with the slightest tighten
Vice or clamp to hold
Safety glass
Optional sandpaper- I gave a quick wet sand up to 600 grit
Edit- I also used tube cutter but this optional too but definitely helps
Last edited:
