pid

Hello guys, I don't know what to do anymore, so I have to ask you for help and tips. I have a Flowerpot B0 injection ball vape, and from one day to the next, it just stopped working. The display on the controller turns on, but the nail doesn't heat up anymore. The display only shows the...

The vid is Here and I was curious if others have had the same experience.

I have this station https://www.amazon.it/Stazione-saldatura-Preciva-stazione-calda/dp/B08C51QRH5 , I was wondering if it was possible to use it with a coil, but I realized that all coils have 5 pins while the my station has 2 sockets, a 7 pin female (heatgun) and a 6 pin male (solder), I didn't...

How should I change the PID variables to fall as little as possible below the set value? Overshoot would be quite indifferent to me, possibly even practical when dabbing. After "AutoTune" it drops 20° Fahrenheit at one hard pull with the Weedeater. PID: xmt7100 / xmt7200 / Newvape PID / most...

Hi all! I've followed what another poster posted: Set the temperature to 400°F (with the coil On? And at temperature?) and then Hold the ">" button until the light starts flashing quickly. My coil isn't hot and obviously not at 400°F. Am I doing it right? I ask this because I've been waiting...