Search results

When I block off the air inlets on mine it is still possible to draw on but with increased resistance. By looking at the photo of the hole where the wire go through, it is tiny opening so if not sealed, it will restrict air flow. How the wires are attached to the heater ?

I can see the air path and also see from where is leaking Iso in the electronics. This is not isolated air path if air from the electronics is sucked into the heater mixed with the air from the air inlets and then inhaled. I'm asking them before I put apart my device and destroy it in the...

The silicone gasket probably is not where the leak is from. I'm 99% sure that is from the base of the heater case where the wires gets out. It is supposed to be sealed with some kind of epoxy and probably mine hasn't been sealed properly, they have forgotten to seal it or decided to skip it. On...

I've tried to block the air inlets and it restricts the air flow but not substantially. The flow with the air inlets unblocked also feels a bit restricted so it creates negative pressure and I'm sure I'm inhaling all the farts from the electronics there is. No answer from the representatives yet.

My taste and smell receptors are working fine and I have been working enough with solder to recognize solder fumes smell. It can be tasted and smelled when run empty otherwise the CBD flavor masks it. Perhaps dirty devices also will mask it even if run empty. The device doesn't behave as...

I have added photo of the literally first comment in this thread.

Because on empty device higher temperature and a bit longer session, I can smell and taste the toxic solder fumes, the whole device body warms up. I have read in the representatives comments that is with isolated air path otherwise I wouldn't have bought it. It is literally written in the...

It should not be a problem and is per instruction of the topgreen/Xmax representative. I'm attaching photo of his reddit comment. The issue is that mine starts leaking from the USB C port instead of the air inlets. The other owner has the same trouble with his. So our air paths are not...

Dont know. Im also curious. You can easily check yours by deep cleaning with 99% Iso. When you sip ISO in the heating chamber if it starts leaking out from the USB C port then is the same.. Just make sure it evaporates before turning it on again.

Hi, More than half an year ago I wrote here that the device has weird taste when heated up empty. I have a doubt that it is vapor from solder at the heater, you wrote me that you will check with the manufacturer how the heater wires are attached but never came back to me .. I have poured 99%...

After 1 hour at 200-210 degrees Celsius in the kitchen oven, finally the smell is gone. But I'm wondering why the device itself Xmax V3 pro also came a lot smellier than my Arizer for example. Is it actually food grade, high temperature silicone? Also I'm wondering are the wires to the heater...

Hi, I recently acquired the device with WPA and dosing capsules. I have noticed weird smell from the silicone gasket on the WPA adapter which remained after washing with iso and hot soapy water. I have just popped in the kitchen oven at 200 degrees Celsius and the silicone piece started fuming...