Search results

Thx for the tip on the pass through adapter. They’re currently 30% off on VGoodiez w code 420VGEZ30.

What is the SBL bowl?

The width is different in each one’s specifications.

In the 18mm scenario, it refers to the joint size too. This bowl is 18mm at joint but the bowl Opening also seals well w many popular 18mm injection vapes. https://grav.com/products/19mm-grav-male-octobowl-clear Was curious if the same is true for the 14mm...

I have a ruby ball modded DBV w the special DDave wand and I enjoy it much more than the Elev8r, TiTi, and other ball injection vapes. W the DBV between 10 and 11 o’clock and a DDave wand I can get big clouds and 1 hit extraction from 1/4 tsp of material and stay well-medicated for 3-6 hours...

Speaking of suitable injector bowls, we’d found that the 18mm Grav Octobowls pair very well w TiTis, Elev8rs, and the Z1.7. Doing so gets the heater nice and close to the herb and provides an all-glass vapor path. Does anyone have a 14mm Grav Octobowl to pair w their SX and see if it seals well?

Not sure which thread would be best for your question (mods can move if they like) but I think that 8786D uses a 9 Pin female Jack on the hot air side and a 6 pin male on the soldering iron side.

For this build, is there a recommendation for stretching the coil vs leaving unstretched? @slikrick photo shows a bit stretched and @VGOODIEZ photos show unstretched w most of the coil on the top 1/3 of the post.

I had this happen w soda lime glass; hopefully won’t happen w rubies.

455 on which controller? That sounds great!

Any advice re: how full the heater cover should be w Ruby beads? I currently have a combo of 3mm near the bottom and 4mm up top. The smaller surround the rod near the base and in front of the rod while the larger fill space behind the rod and near the top of the heater cover. It’s packed tightly...

To find my sweet spot for draw resistance, I kept approx 25 3mm rubies and took off the air inlet screen. May have defeated the purpose of the rubies this way, but it’s more comfortable for me. Thx for the suggestion.

Do you have any estimates for the min temp that might do that?

And also among vape styles. If I can get satisfying convection medication from a log vape at significantly lower temps than injection, a log might become the daily driver unless the hotter injector posed no significantly elevated health risk.

Was thinking about long term effects of regular exposure over time vs a single inhalation. Temp probe in the vessel and by the mouthpiece sounds like the way to go. Great idea.

I’m neither doctor nor chef, but I know that we can use convection heat to cook proteins at temps under 500. I’ve never measured the vapor temp coming out of a stem, whip, or tube. Could convection hits above that “cook” our airways (e.g. 575-600 on a DC controller; iirc potentially higher on...

Flavor can be great; especially around 560. Here, I’m running it a bit hotter to get w quick milk w low drag; tasted terpy but toasty. Works w 18mm female joints and injector bowls. This Bowl is the 18mm Grav Octabowl.

Inverzion 1.7 on DC 3D @ 580 🥳

Whether legacy devices or new innovations, invertedisdead engineers excellence. While waiting for the next round of Z8s, I brought out a sapphire 1.7 to pair w a new glass. I like a slow draw w mnimal resistance and I’m always amazed by how open this feels for a heater w balls. Trying to figure...

3mm rubíes right now. Was hoping they could stay so I could enjoy lower temps.