Search results

I am Nomad II #7. Still patiently waiting. :-)

OK. Assuming you downloaded both, you need to run the installer and select the update file. If they both come zipped you need to extract them from their compressed state (unzip). The questions you needed to find out and I don't have the knowledge to answer are: is your Mac unzipper compatible...

I'm not sure if unarchiver is compatible, but what program are you going to use once you get the file unzipped?

You were able to unzip the file with 7zip and extract the contents? Once you do that when you run the firmware update program it will ask for the file. Browse for where you extracted it and you should be good from there.

I'm using a gen3 at 41 watts. There is likely some variance in resistance from Splinter to Splinter. That is at least my baseless guess.

How do you get the milk film off? Soap and water bath afterwards?

No support for the gen3 yet, but if enough of us ask it might happen sooner than later

I think kleptocrat is a better description. True commies would be ashamed.

How did they say you should do it? Half a whole bean?

I would suggest for anyone using these variables to lower the wattage to 45. At 70 that means that the heater could pulse at 70w to maintain a temperature of 200c. The literature I got with my device says to keep the wattage under 45. Edit: also, since each heater will vary slightly, every...

I've asked FJ about gen 3 support as there is a branch of myevic that supports that mod (which is a great mod). FJ said he will work on integrating support for gen 3 in future firmware released.

Do you warmup? My SO uses it at 41, seems to be when the vapor starts producing on our mod.

Reading the email was devastating. RBT was ahead of it's time it appears, as the legalization movement continues, the businesses that plant themselves firmly set themselves up to be successful. I guess that is the gamble in these ambiguous times...

I'd have to say this is normal behavior for single cell evic dual configuration on my TUBOx. I would suggest taking a bit more time between rips, and using the warm-up to cruise mode to get started. It's all about how much heat is generated to get through your bowl.

You're welcome. I know this has worked for others here. Feathering the button on demand helps, as does enabling eco mode for cruise.

Do you remember on which menu I can adjust wattage?I couldn't find it myself... :freak: Go into interface and set "edit" to one of the clicks (I suggest 4). After clicking into edit you can cycle through the various on screen numbers. You should be able to select wattage and lower with the...

I think lowering the wattage from 75 will help this a lot. Also good batteries are a large contributor. Edit: a word

I get some of my thickest clouds through my TUBOx. I crank it up to 480 though. Seems like on rare occasions the wattage fluctuates a lot during a draw and I'm not getting hits as quickly as I am used to; I will pop the batteries in and out and then it's back to champ mode. I think it's my evic...

Your local stores didn't have any decent ones? eBay from a trusted seller that has specifications listed might be your best bet. I will agree the the quality is highly variable, so definitely don't go with the flashy colorful ones. Get a stainless steel heat sink.

Get a nicer heat sink, a stainless steel Kepler or the like.