Search results

I just got a Hannya clone, been using Evil Monk with a RxW DBC. I like it so far. More vertical room is definitely good and I like the airflow. I'll probably order a real one now. The screw posts seem a little small compared to the hole and seems like it is easy to "miss" the wire a little, but...

That is actually pretty good, .7ohm and 10w. Just a little smaller would be good. I just eyeball the leads, basically bend down the smallest amount I can which is usually pretty close. I think my current one is a hair too tall because sometimes I have to scrape some stuff off the inside of the...

What awg wire are you using? I am using the same Evil Monk RDA with a RxW stovetop. I'm still using kanthal and haven't tried temp control. I was using 26 awg but switched to 24 awg which created a much sturdier coil. But it was around .2ohm and heating up very fast even at the lowest setting. I...

I've been using the Evil Monk. My airholes did get filled with reclaim or runoff after a while. But my buddy says he gets no reclaim at all. I think it is a difference in efficiency, he takes huge pulls and I'm a choker. I'm probably putting too much on and then letting it melt, but it is hard...

I got my Evil Monk DBC back to a more normal range, .6-.7 ohm depending on wattage, which is still all the way down to 6-8w. I'm back to the 26awg but will try the 24awg again. The problem was probably just the length of the wire. I was trying to make a smaller coil to begin with, and sometimes...

Thanks for the info. I did have an iStick 40w TC but lost it this weekend. I didn't use it on temp mode because I'm using kanthal but it did heat up a lot slower at a higher wattage and was a smoother hit. I'm looking at the Smok XCube 2 too. The red in the pic was when I was burning the wick...

I made a new coil today which is smaller by one rotation from the pic, but the new one is not really pretty enough to take a photo. I'm using 24 awg wire now, it seems a little sturdier than the 26 awg I used previously, which would bend too much after use. I have it down to 7.5w now and could...

I've been using this Evil Monk postless RDA with ReadyXWick for the past several weeks and have barely even touched my torch since building this thing. I made a smaller coil by half a rotation after this pic that works even better. Have it all the way down to 8-9W on the Smok Xpro pictured...