Search results

You're absolutely right...my TM2 has this inner glass tube, the one that carries the screen is made of SS. Sorry @invertedisdead

You're right, this depends on the use. I'm not a microdoser but my sessions are quick... 5 seconds/hit x6 and only one session.

Yes, I have the TM1 and TM2 with the ss liner.:rolleyes: So I know what I'm talking about from my own experience.:science: If you haven't tried this cooling system, I don't know how you came to that conclusion.:hmm: This 6cm TiStem with capillary tubes cools just like my 10cm spiked glass stem ...

much more air flow in my Fw7...

Zirconia seems interesting to me for a stem, but the original CU is the only drawback in the "TMs" The short Ti Stem that I've been using for almost two years works perfectly with this cooling system, which in addition to cooling the vapor a lot, lasts for weeks and weeks without clogging...Of...

I doubt it's the batteries... Follow these tips below, starting with cleaning the threads of the battery cover and top plate. EDIT: confirm that the main screw is very well tightened (very well) maybe...if you notice that it reaches temperature faster :nod:

So the update is just the vibration when you exit boost and fix error04?

simply wipe with a dry towel while it is hot.

@scal_m My supplier cannot find titanium with the correct diameters...I don't know when I will make stems again...if I do sorry

:hmm:...better check if you are not crushing the batteries

Have you cleaned the threads on the battery lid and top plate? Batteries also gain a residue In my experience, when batteries start to get tired, they do fewer sessions. some reached the point where they were 100% charged and couldn't handle a full session. The health values of these batteries...

I don't know:hmm:...you can find a little bit of everything there. Isn't that where everything is done??:D If they don't make it original they make it fake:mental:

It's essential to have a backup...a vapcap solves that! It's different from when the shrouds ran out! ...more than 8 years since the last time I lit a cigarette or joint:rockon:Thanks FC

:doh: Hmmm... Now you know that for some reason he is there! Send it to repair...don't waste your time

No... The idea is to add about 1mm in height. Make sure the foil is compressed well... If it were me, I would calibrate the TM to maximum

I don't think it's because you reduced the bowl!:disgust: Maybe the quality of the greens? less resin? :hmm: Maybe it just needs to be recalibrated...if you raise the temperature you'll get the same results as before? Don't do that... :doh: just clean it with a cotton swab and ISO...if it's...

After each session?? :lol:That's not for me... :cool:I still don't have that much free time...👔 On Venty I have always used the brush... and that was the problem In my craftys I never used their brush... I used a tissue right after the session ... not always As I said before, I had more than a...

forget that for now... the difference is that paper compresses more easily and over time it can lose its strength and not help the contact I haven't seen your coil without the heater screen yet...have you? There are two very fragile ceramic pins that cross the coil from one side to the other...

i changed the oring... I think it matches EDIT: It was dirty...very dirty:doh: