Search results

I have, but much prefer the T2 stem I think, but mainly because I much prefer using it on a piece via the WPA.

I never got on with the Dynavaps personally. I've tried quite a few and I've sold them all since getting my tempest 2. All I have now is a T1 and T2. They are miles ahead of the Dynavaps in my opinion, it's not even a close comparison. For me, the Dynavaps are too tight on the airflow and I...

Yes it did. I think it helps the end of the reload tool is a little sticky, so it holds the screen nicely. @Grass Yes Using the reload as a funnel is an ingenious idea! I'm going to try that next time thank you.

@BearFuur Have you tried using the screwdriver / debowler tool that comes in the Reload 2? I find that works perfectly for doing the ball screen.

For those of you using the V2 wand adaptor and the tempest 1, do you set the depth the same for tempest 1 and 2?

If I remember correctly, some of those videos with loads of hits were using hash and flower. The hash can go for ages. I also find slightly more humid material gives off much more vapor. Silly question I'm sure, but you do have it set to full bowl?

I prefer them for the smaller bowl settings. I do think the zirc are the best for clearing the full bowl setting without having to go up to a really high temperature on the wand. Am I right in thinking that because the wood sleeves are stabilised, we won't need to wax them etc?

I will hold of another gen 2 and wait to see what's updated and get some new colours! Thank you.

Are there any changes to the reloads and will they be available in the new colours?

These are all so nice! Are you still just doing these with a drill? I wish I could help with the mystery wood type.

Airflow is much simpler on the V2, it's just the adjustable airflows on the cap and then the rush hole open or closed.

You can indeed just pull it straight out. It's held in by two o rings.

I'm not sure which page it's on, but there is a guide with picture in this thread.

Thank you for uploading! That looks like the C tool for setting the bowl depth. The ones we've seen so far have been 3d printed, so it's good to see a proper version! I didn't get either version and it is a bit fiddly to adjust the bowl without it. I wonder what the tiny little hole is for 🤔...

Very interesting, could you post a picture of the C tool? The bowl should just pull away from the stem?

Evening everyone. The wooden sleeves are back in stock, and I noticed there are some factory seconds up for grabs Factory seconds. @onedeep601 & @Cru , can you share your settings etc? I find using water piece, but without any water in it, really helps to cool the vapor.

I really like the radiator fin holes on the first one. Amazing job considering you don't have a lathe.

Happy to report that the WPA part of the wooden heat shields works very well. The detail in the maple burl is amazing. The green one makes me think of van Gogh. Thanks! Really happy with them and they do a great job. @kokolokokolokon , the Imgur link won't connect for me, but I'd love...

The gang, green wood, titanium and black wood. The wood looks and feels amazing. Very happy with these and I really like the little MAD engraving.

My money would be on Borosilicate, I got some for free with my order too.