Search results

I haven't posted in a bit and missed a lot, but feel that I should check in. I'm sure much of this has been mentioned, maybe even so on this last page but I'm going to post anyway. I'm on my third V3. Ordered white upon release, then black because I noticed it was new, then another black...

Sorry for all the replies, still learning the forum. As for recommendations on the V3, I think a one-piece mouthpiece that mates to the deck with o-rings would be great. It's so much easier loading the deck and getting everything positioned on the donut where I want it with the base off. I...

At 40w, I wait about a second or until I hear it doing its thing. Then I start to pull slow and increase speed as the temp rises. Very important to me: letting off the fire button early and continuing to draw for a few seconds while the donut cools back down.

I get terrible tasting above 400. 350w seems right but I guess that could vary between mods. I'm not really sure how it reads the temp, but I would think material, density, etc of the atty could have an influence. I shoot for the higher wattage to minimize ramp up time and negate the...

No, I do a full breakdown and disassembly for scheduled cleanings and field strips in between. When I adjusted my cup, I snipped a millimeter or two off of the bottom of the leads of the donut. The leads also caused the donut to sit up a little higher because the leads were bottoming out...

I've been experimenting a bit. I finally got it to partially glow last night just after scraping the face of the donut clean, lightly of course. It was partially white, not that brand new white, but marbled looking. I was running it at 20w in wattage mode and pulsing it until it glowed. The...

I feel I should post my mistake so that it doesn't lead to problems for others. I adjusted the center pin screw because I felt it was not sticking out far enough from the bottom of the deck. What I think happened, was when I screwed the V3 on the first time, I pushed the pin inward. The...

I've been rocking the V3 at TCR 245, 40w and 350F and McLovin' it. It took a bit to figure out but this is all still new. I am having better luck putting it more around the donut than in one spot. I will lower the disc further in the cup in a moment. It was only a bit of wobble but I'll...

I'm cleaning my V3 for the first time and have a question if anyone is familiar with the location of the ceramic ring. The ring is suspended about a millimeter or two above the cup. This is causing a bit of a rattle with the cup because it is between the ceramic ring and the deck posts which...

I'm using a TCR of 245 with 32w with a temp of 350-380. I haven't broken anything yet and feel like I'm getting better hits. This is a first for me so I have nothing to compare to. I put food grade silicone spray on the mouthpiece to smoothen up the o-rings. It's much easier to pull off and...

Days ago, I coincidentally stumbled across this thread in my search of a build that would suit my needs and within an hour or so of the post releasing the V3. I have recently quit smoking cigarettes and adopted modern vaping. It led me to believe that something like the V3 existed. I am now...