Search results

You're welcome. I'm fine with 'early recharges', being basically lazy I usually run it down but if say I'm going out or have other 'need' for a full charge that happens for sure. If you look at the Battery University data, very little penalty is paid if you stay away from the very top and...

Sounds like a great routine to me, betters the bond between man and machine! At one time I gave some passing thought to making it easier to harvest reclaim. Perhaps we get Ed to make us a stem that will accept a glass tube as a liner? Something easy to remove (like a hook on the end of a...

Thanks, I'd assumed as much. When you say you "fail to understand how echoing, ambulance chasing, spin doctoring, and incessant negative harping contributes any new objective, useful, and productive information and guidance beyond the original report" I think you raise a good point, but...

Excellent attitude, but I hope you see how that can call your objectivity into question? IMO that means you need to back up opinions with solid, verifiable facts. Agreed on both counts. If it can deliver on even a fraction of the original claims it has lots to offer (at least to some users)...

Up until demand drops and the stop making the stuff. To prevent that, I think you should buy up all you can find........ OF

No linkage, not a feature. At least as I understand it. Even when the battery is 'dead' it's not. The processor has just locked out heating. It (the processor) is still running, same as always. Somewhere, as the voltage decays the flow detector will give up working. But when the unit is...

Amen! I think a great 'first thing to try' in most/all such cases is to slow down the draw and see what happens. Sipping usually pays off. If you check out those astounding videos of little guys like MFLB 'chalking up the WT' you'll note they filled the WT very slowly? No faster than the...

Once again, guys, I think grind is a refinement not a key? You can get good vapor out of intact buds or powder (and anything between) if the herb is even OK, let alone good/great? OF

Yes, the cutoff voltage was lowered. It will continue to heat to a lower level on the battery now, it would seem at least sometimes under the minimum voltage to run the e-cig detector? That, I think, is the only link......the processor doesn't run that light. That light is part of the sensor...

If you read again, you'll see I sent the old one to Joe and he sent it back? Yes, they both have the same software (the one on the EU link). The older one (along with 'all' the ones under S/N 100) needed a firmware upgrade to load the new software. The LED on the top is an indicator only for...

Yes, we all do. Except those using PVHES or Ed's with notches on the rim. It's normal for the flat end of the stem to seal against the flat bottom of the oven. It happens on Solo too, of course. Some lift it a bit, but I think most simply tip the stem a bit? This is discussed here some but...

You've got several choices. One is to dissolve it in 'juice' (same as e-cigs and fog machines use), typically PG or Vegetable Glycerine or a mix of the two. There's some excellent information on this from an old post (on Grass City?) by no less an authority than "G", owner of Delta 9 and...

I agree, that's what I found and reported here a page back. I think it's important to remember that the 'hit count' one guy gets is not a guarantee to the next. Perhaps the biggest power issue is not normally mentioned, convection heating. ESV doesn't heat your herb (at least not directly)...

Great, glad you got on board. FWIW, that's a heat exchanger not "flame filter" (what is there in a flame to filter out....it's gases). The soot is because the exchanger mass 'robbed' the heat from the first reaction (Hydrogen to water) necessary for the second (Carbon to CO2) leaving the...

The answer is 'it depends'. Isn't it always? It depends on what you're testing for. Cannabinoids are done by HPLC as I understand. Fungus, mold and mildew by trained observation (light microscope). Pesticides by specific chemical test. The gear to do this sort of stuff can be mighty...

No, they're not. The tabs are in the bottom plate, the screws go through them upwards into the tube. Normally you don't mess with them unless you're opening it up (like to get to the bottom). Remember, the issue the o-ring is intended to 'fix' is to keep the bent stem from rotating on it's...

Get real, a TOTALLY INSIGNIFICANT level. Trivial. Stop trying to scare the straights? Exactly so. Butane is a common propellent in modern spray cans (now that we've banned Freon......just as DuPonts patent ran out.....), folks who say work in hair salons probably breathe a hundred fold what...

Sounds like a good plan to me. My advice (and what I do) is to run it down fairly far as a matter of convenience (but never more than 'one last session' the first time it shows no lights on the 'battery meter'). There's a modest reserve at the bottom, but deep discharges also limit life. The...

Cool, does it actually run as long as when new? Those numbers are based on voltage, not really capacity. I have a DVD player that shows '100% charge' but won't run it more than 15 minutes. It takes a small fraction of 'nameplate rating' to fully recharge it, it recharges in less than half an...

Great! Now the list of unanswerable questions is down to two: What is the meaning to life? Where can I get a good aphrodisiac? Which shall we tackle next? OF