Search results

Actually, no I don't. It matches very closely my other FMs (and other vapes I trust like Solo/Air). I have not measured it for that reason. Yours could be defective, of course, but I highly doubt it. On what do you base your suspicions? As pilots say 'trust your instruments'? OF Edit: In...

Listen to LH, I've pulled one apart a fair bit (and reported as much here, you might search?). Not only do you damage the area around the buttons (the bezel is glued on after the unit is assembled) but you can't truly clean all the areas enough to avoid detection. They could simply rinse the...

I don't see why not (at least the ones that fit), but since they're not the approved battery I've never tried. Nor do I recommend it for that reason. OF

Or longer time at the same temperature? More calories, but not degrees. But once there you need no more heat to keep it at temperature but you would if the heat was conducting through thicker glass? If the heat goes around it (in the air) I would not expect that to happen. OF

Yep, that's what I find too. Another anecdotal observation to support conduction over convection heating. If the work was done by heated air rather than conduction though the glass it wouldn't be so? I find this also with the Vortex stem, even more so? It seems to take higher heat settings...

It's easy to forget how blessed we are here for the most part. Lots of models to pick over, reasonable prices, guaranteed and prompt delivery, excellent support and so on. Others have a much tougher time getting their vapes for sure. We had an Indian fellow a while back who's trials would...

I too thought it was. There's a LOT of discussion of the eggs, what else will fit in, how to stop rattles, different colors, excitement over the clear ones and so on. I'd guess that the majority use them, and even those of us who have alternative packaging like this: still use their eggs (I...

Well we might be, but I think this time Ataxian is the only one that's wrong......the rest of us are bought off or too dim to understand, take your pick. In a rare serious moment I'm not sure I agree FM is inferior, only different. For a given set of conditions Solo/Air might have the...

Where are you? In the US? If so, PM me and I'll mail you one. OF

No, not all of them for sure. They risk 'but my Solo always does better' kind of replies same as we risk evidence backed challenges here. Like if we said 'biggest clouds ever'? In a useful way wild claims quickly get called out, lots of experimenting going on by good folks making accurate...

No parts list, really. The only two important parts are the Arduino Mini Pro (although other models and other micro controllers will do fine) and the FET used as a switch. Low internal resistance and Gate sensitivity in the 5 Volt range of the processor are keys, I'm using IRF 530 but again...

My guess is it's glued on with fouling/condensate and is not going to come out cold. And it's possible that now that the plastic (which was insulation) is gone it doesn't get hot enough any more to come free. You might try a bead of ISO around the tube end (the one inside the broken MP) and...

Yes, the second photo (of the bottom.....) is where some put a screen, some are OK with herb leaking downward and don't? Either way is OK probably, try and see what you like? Originally they came with screens pressed in (very hard/impossible to remove) but guys were putting damp herb in and...

First off fully charge it before anything else, in fact 'overcharge' it an additional four hours after it's 'full'. This is/should be standard drill for all such (Li-ion) batteries on THE FIRST CHARGE ONLY. After the first serious discharge (like testing or a session) any potential to increase...

9VDC at 3 Amps, but IIRC one Amp is enough to cover worst case charging. It's an uncommon small connector, the same basic one used by FM in some of their vapes in fact, but LONGER THAN NORMAL. That is the connector from FM isn't long enough for reliable connection. I had to make one for my...

Amen. Even if not right for you right now, or for that matter if you never take advantage of the opportunity, more choices in the market is a very good thing to happen. OF

I think Aura is about average for such vapes. In fact, perhaps on the fast side of average? The actual heat up time depends a LOT on the charge level. I just timed my first heat up/burn off on my new unit from full charge. A couple seconds over one minute, in fact by the time I'd wound the...

I hope what you get is the genuine article. I got both of mine from PIU and am confident mine are (just got the second one this morning (ordered Friday after hours!), it's charging now). There are counterfeits out there no doubt as well as 'black and gray market' ones? And of course service...

You are not alone, just not one of us...... OF

Agreed. Pretty cool. We do this as well (to a less precise degree) when we heat longer for hits when cold. We guess at the compensation needed, the HS can make an approximate measurement to base the timing on. And unlike with you and I the effect of the THC is not likely to interfere with...