Search results

sounds interesting, was going to look into hacking an old pc power supply will have to watch a few vids and get the multimeter out!

i let mine go down to about 20% no idea what proper use is but they’re too cheap and expendable for me to be bothered, i notice the performance drop significantly below 50%

yeh mines still in warranty, otherwise they wouldn’t offer to fix it for free lol. dont know if you will have it fixed or replaced, this is my 3rd warranty and the first time ive had anything other than a new unit is being dispatched.

Mines in for RMA for damaged housing and they offered 80 euro to replace or repair for free. I opted for free obviously so let's see if it actually gets serviced....

i keep being too much of a stoner and forgetting to toke until cruise is almost finished, how about double tap to reset cruise?

arcic fox was just released for the Ikonn220 (the mod that wouldn’t project) now all is good with it stock firmware was just too shit, nice little mod now!

thumbs up for the new firmware cheers funky!

gen 1 with 14mm female wooden joint

yeh im half way through making a stainless wood sleeved heater its just too fragile as is , for outdoor use anyway

is it effecting your draw much? can you not adjust the heating curve a bit?

just upgraded the rx200s to arcticfox, massive improvement over stock tcr, shame there’s no cruise

ok so i was right about the sf, just the mouthpiece rolling from my laptop onto the table caused a crack in the end of the mouthpeice, luckily ill be able to grind off the flare and it will be fine as that’s where the crack is, in the mean time, with the correct o-rings anything is possible!

yeh i would get an eraser for outdoor use, i can see me smashing the sf. also pipes how did you construct this mouthpiece, is it safe to soak in iso with the shrink sleeve? also been using the sf all day and hasn’t once bounced back to watts, this 3 battery mod is a heavy beast though

Reuleaux 200s seems to have solved the issues...avoid the ikonn 220 for the project and any thing TCR related I would say

nothing keeps it on tcr just ordered a used reuleaux 200s for further testing when it arrives

had a long fun night of testing coil building and vaping (super fun for the girlfriend lol) anyway i got a couple of nice builds and they did the same thing , you can session then as soon as the device goes cold if you try again it will kick straight to watts as soon as it reaches set temp, pull...

yep they are the ones, like like duff said though you will probs find you dont end up using them much

there too small, need extreme q ones

cheers pipes, ill have a mess about with it and maybe try it on one of my brothers mods at sunday dinner. will let yous know when i get it stable ;-)

thanks for the help pipes and zen, ive repositioned the washers, no atomizer short but its doing the same thing, you think the fact that it works for a couple of sessions means it could be a firmware issue? obviously i know the only way to verify is to try with a different mod!