Search results

Amboyna:D Here's a shot of that body with its matching red mallee mouthpiece.

I have a few of every generation, haha. The LE7fin's are really easy to swap out when they are warm which makes them my go-to tip.

The way I always check is by tapping them against a magnet. The stainless variants are slightly magnetic, Ti is not. To the best of my knowledge, that is correct.

I have a dozen caps, it can't happen. You're not bending with enough force to properly deform the cap so it'll properly fit. Squeeze the sides opposite of the digger tool, then bend the digger tool part inwards a bit. I've had caps that fit really loosely at first to the point where a click sent...

Honestly I'm pretty bummed with the quality of the XL Omni I picked up, although I've been on the Dynavap bandwagon since the very beginning. The machining is like a 6.5/10 for the Ti stem and my condenser is like a 5/10. Also I had to do some deburring on both ends of the stem, and inside of...

I received that letter today, I think everyone is going to be absolutely elated by the resolution. Dynavap and Joe really went above and beyond anything that I've ever experienced to make things right. @VapCap @Vapcap2 Sincerely, thank you.

I've posted this in the past, but here ya go! George only made a couple (I'm not even sure how many, this was a long time special request), it was a very limited run.

New with old. Limited edition 7-fin and amboyna burl body. Tomorrow marks the two year anniversary of when I purchased this beautiful piece. I was one of the lucky people to pick up one of @Ed's TnT's first burl stems he made for George. Aside from my Damascus Omni this has been my most...

Thanks! Other than looks, it's identical. They fit a bit more snugly on the heater than my older 7-fin tip, but exactly the same as the newer ti tip.

The limited edition 7-fin tips look so good on my WS.

Same, I have a dozen caps/tips and they all seem to have a unique fit. I usually roll the entire cap between my fingers applying pressure right in the middle. That way the bottom doesn't bow out but it grips better. If that doesn't work, you can even mildly bend the digger tool part inwards as...

Performance is virtually identical, there's a tiny bit more airflow due to ever so slightly deeper groves on the sides of the bowl but it's barely perceptible. It does sit on my Ed's WS a bit more snugly than my older generation 7fin tips though which is nice.

I imagine they'll be extremely similar. The newer 7-fin does have ever so slightly better airflow. It looks like the groves around the bowl on the new 7-fin are a bit deeper. In real world use, I can't imagine they'll perform any differently though. The one major change is the fins, they look...

New 7-fin vs old. The machining is flawless, no sharp edges it's all very smooth.

New 7-fin vs old. The machining is immaculate.

Sorry for the late reply! Life has been far too busy lately. I have a feeling you’re going to be extremely happy with the WS. The 12v heater is very efficient and the airflow is perfect in my opinion. It handles dabs like a champ.

That's pretty much what I use mine for, it works extremely well.

I’m in for two

Count me in for one.