Search results

I had a similar initial reaction. That said, I like the way the helix pill functions the best out of the two helixes, both of which are better than the stock. And for $50 it is a very nice piece of glass.

Very fine question

I purchased my replacements. Got them in 3 days

@Fkn0wned – with your source heater...did you use the ceramic & plastic wire sleeves from the original carta atomizer? I was able to successfully get a DT donut to work on the carta, but the alignment was to high for the Ti bucket

IMO, your current situation sucks, but should be expected during a pre/beta release. On a different note. Tried the short F bomb today. It is excellent too!

Yes. That was the same way my first atomizer went out.

The long neck hasn’t come off my base since it arrived. So smooth and just a rock solid feel. Once we have temp control via the app (and buckets other than Ti) the Carta will be hard to surpass.

Both of the glass upgrades have helix f bomb stamped on them. Which one was it?

This is exactly how I use my 2nd atomizer that runs too hot. I have found that the atty that runs too hot also tendsto boil over way more than the atomizers that are running at a much lower temps

Couple of updates over here. My third atomizer (original design) is working great. Lowest temp is good. Hope it lasts until the new version arrives. Speaking of arrivals, both of the upgrade glass pieces came in today. Both have a great fit. Have only tried the peak helix. Wow, very nice piece...

This second atomizer runs stupid hot. So hot, that my current routine is start the low cycle, drop in a very small dab, draw, and as soon as I see thick vapor, shut off. This usually gets 2great rips. Then I heat again, shutting off usually before it even gets to green. A couple of less-terpy...

You are. Or missing out by not using the quartz. They don’t work worth a crap on the pre-order atomizers. Based upon the build I don’t see any reason why you couldn’t do an iso soak, but you will probably want to make sure that it is compels dry before use...like, 12+hrs directly in front of a...

Ok. So the second atomizer is running way hotter on low heat setting vs. my first. Really wish I had the app to tone it down

My backup atomizers arrived. This time, the first dry run and use were normal. The third use produced the run-away red hot bucket until I forced a shutdown. I quickly took the atomizer off, and removed the lid and bucket. Let it all cool down and the next use was perfect. Strange.

This was exactly that first dry run experience that I had posted about earlier in the thread

Well, looks like I have burnt out my first atomizer. It’s heating, but no where near the temps required to vape my material. Have tried readjusting but no luck

i am really starting to think that the small cups are the main reason that the carta is so much more efficient than the peak. Only reason that I have even touched the peak in the past week is because I like the flavor profile on SiC better than Ti. That said, I have only used my peak 1/5 of the...

I literally only put a single small dabs worth. I also qtip after every use. There is literally no way that I could have the volume of “overflow” that your pictures represent, as I never have that amount of material in the cup. Also, yes, out of anxiety of the potential for overflow from the...

I haven’t had the overflow issues that some of you have expressed. That said, I have only been using Ti buckets, with very small loads, and a preheat before I load. Best I have found yet is to do a level 3 heat cycle, then melt in a nice small sticky diamond, with a level 2 heat cycle then applied.

Thankfully after that first dry burn, my level one dabs have been nothing but Terp town. Going to give the quartz a whirl next.