Recent content by Zanin

  1. Z

    Hex-Nail (HN-01) - RIP

    I never switched any coils yet, even tried turning it on without a coil, no lights still after 10 min except on the power switch itself.
  2. Z

    Hex-Nail (HN-01) - RIP

    My Red Queen stopped working after a couple months. The lights just don't turn on when I hit the switch.
  3. Z

    Hex-Nail (HN-01) - RIP

    Finally got it on the correct network after power cycling and waiting 15 min. I am able to change settings without it resetting now.
  4. Z

    Hex-Nail (HN-01) - RIP

    I got it connected but now I'm completely lost, every setting I change resets and I can't get the heater to set to on it always says off and temp is stuck at 199. It has an SSID network that I disconnected so I'm not sure why it still shows it connected...
  5. Z

    Hex-Nail (HN-01) - RIP

    Got my hex to the blinking green state, connect to it the hex network on my phone, open up my browser to setup wifi but it gets stuck at attempting to connect and error checking connection status. I switched routers too and even changed SSID's still no luck.
  6. Z

    CCA Liger banger V3.0

    I noticed that when I clean my insert after dabbing rosin I press myself with 90 micron screen it's not clean after 1 q-tip swipe so I have to crank it down to 300 and use 5-6 q-tips... I get this golden crumble from another guy and it only takes 1 tip of a q-tip to clean it. Rosin seems to...
  7. Z

    Hex-Nail (HN-01) - RIP

    You should include a light for cleaning mode @ 250-300 degrees because dirty nails are not good to breath in, I tend to clean my insert on my liger banger v3 every dab.
  8. Z

    Hex-Nail (HN-01) - RIP

    Any news on shipments? Anyone got one yet?
  9. Z

    Hex-Nail (HN-01) - RIP

    I've never seen that email yet and I ordered Sept 25th.
  10. Z

    CCA Liger banger V3.0

    They could just put the serial # on the bottom of the insert, wouldn't effect the top.
  11. Z

    CCA Liger banger V3.0

    Do they ever send out emails with tracking? Because I ordered liger banger 20mm rainbow one on sept 20th and the obsidian insert earlier than that, still no email of them being shipped.
  12. Z

    CCA Liger banger V3.0

    On their site it says obsidian inserts will be shipping end of september. Anyone get their tracking numbers yet?
  13. Z

    CCA Liger banger V3.0

    How long does it typically take for CCA to restock their 20mm bangers? I need one really bad.
  14. Z

    The Herbalizer

    They should've had this steamroller on release day of herbie. It blows any adapter + hydratube out of the water, and forget the bags and whip lol. If anyone gets the steamroller they will not regret it.
  15. Z

    Brainstorming with Engineer

    Need to make the Herbie have the ability to do one hit extractions thru glass. When I'm on the go, there's no time for me to sit down with the whip or bag. Have you guys used a sub before? I want to see that and herbie combined, with a reclaim catcher built in. :)
Top Bottom