Recent content by Zagala

Did you try their Reddit account, there is a thread there with some examples that can be very helpful. Vapman cookbook: https://www.reddit.com/r/vapman_official/s/aK4L32LgtV

I personally don’t remember using my TA3 with full bowl (seriously!). Once I tried placing the screen on the ring right at the level of the bottom thread I have never felt a need to change the set up. Even the resulting limited load capacity provides either a few 3-4 hits with a stem and 1-2...

TA in stock again at Vgoodiez!

Condolences. My thoughts are with yo.

Thanks. I ordered the custom stem for my upcoming Tempest but thought I could try it with the TA. And it worked very well and much heat resistant than the revolve with the heat buffer bobbin. I will try with my Mad Heaters Revolve wooden sleeves for now until I get my Tempest wooden sleeves I...

Just received!

I will definitely try this set up! Only thing I don’t have is the MagSink - currently sold out.

Many thanks. I will wait for restock.

Question - would the MH Reload be as good as the PP MagSink? I am asking because the MagSink is currently sold out on the Vgoodiez website. Thanks.

Me too!

Great! Thanks a lot. Will check.

Where are these midsection/wpa available for sal? thanks!

I am not sure if they are still available for purchase but the Dotleaf WPAs work with the provided drip tips. I got both the 14mm and the 19mm (now lost). It is plastic but it works. Edit - Connection does not need the drip tip actually.

There you go. Thanks @Grass Yes. As for tutorial, Alan directed me as follows and I later tried to be creative my own ways (see pics) but the process is the same: ” Draw the paper over a sharp edge to cause it to curl like you do with a ribbon. Wrap the strip of paper around the 3/8" ss tube...

I meant the stainless steel without the nylon. I’ll see what I can do in the morning for the ‘tutorial’. Edit - Also I think that Alan has a roasting tubes thread.