Recent content by turbovap

Mark, I accidently left my cooling unit in in an ISO bath for 6 hours :0 all was well, even the o-rings were fine. Renewed confidence in S&B !!! Made a quick phone call, all is good. Mighty good :)

Just received a replacment Crafty 2 weeks ago, it is firmware 2.07... Not real impressed with there CS. I had a very early unit #545.. It was DOA at 50 hrs. Called S&B, talked to a very nice operator about buying a wear and tear kit and swapping it out for a Mighty. Was told no problem it will...

1 day turn around at S&B for me. Sent in an oldie... #000542, recieved #022000

I had the best and worst experiance with the beta glass spacers last night. Took a small bud, broke it up just a bit in my hand. Thin layer on the bottom, 2 jacks, i more thin layer and a spacer, holes down. Draw resistance was minimal due to not using ground bud. Hits were killer and seemed to...

2 flowers and 1 spacer = (:

Works, Thanks !!! Mine is an early unit #525 Phone is an S5 running 5.0 Lolipop

I did try to sandwich between both spacers last night. had to pack it pretty tight to get it all in there, it got the job done but as mentioned it was a shorter session. I then tried it with the bottom spacer holes down. The cup of the spacer holds a little extra bud. Top spacer holes down. This...

I wish i could better describ how it is acting. Not sure what you mean by write settings. If i open the app and don't touch anything it show's the temp set point and also reads the current temp. If the phone screen times out, after reopening the lock screen the apps current temp reading is...

Here ya go, it's 1/4" ID ( .250 ) OD is .350

But we have " Lolipop" Lmao (:

The S&B app doesn't work at all since the 5.0 update. Like you said, at least this one works for a bit.

I am running 1.5 , it's much closer (: it works from 10/20 seconds to somtimes 1 or 2 minutes. Was able to adjust led and ramp temp. Was also able to adjust vap temp once or twice before it freezes. The temp readout freezes first then it becomes unusable. I am still able to close it down, so...

I tried this app on my S5 with the 5.0 Lolipop update. It does communicate, reads temp for a second or two then freezes. If i clear data and reopen, it does the same.

I'll post up a pic and measure it. It's actually the white hose from inside of a sinus rinse bottle. lol.. I switch out bottles every 3 months. The ID fits over the inner stem perfect and the OD fits inside the upper rubber boot. It's not very thick. I want to take a minute and thank...

Same here. I don't vap above 380 so NP :) Nice !!! I got rid of the upper glass straw. Connected to the lower glass with Medical grade hose. No more air leak, hits way better.