Recent content by SockPuppetTheatrics

I have HI plugged into a smart plug and set up an Alexa routine to turn off at midnight in case I forget to turn it off when I go to bed. I don't feel the need to have it turn on at a set time since initial heatup time is pretty quick. I mostly do single hits with just enough material to cover...

I expect the delays would have more to do with getting the units into the country than anything else.

I started at around 8.5 with the 7/8" metal joint and the glass roasting tube on a dry j-hook.

Probably already been mentioned here, but this N3RD Glass 14mm piece (link) provides surprisingly good cooling, I'm guessing because of the 90-degree angles and moderate restriction:

Ok, this finally pushed me over the edge to pick up a ZX. I was trying to hold out until the wireless ZX happens (which I'm still on board for when it's ready!), but I didn't want to risk missing out for who knows how long it'll take to get this tariff nonsense sorted. Thanks for the nudge!

Mine also broke pretty quickly. I switched to the vaphit case from VGoodiEZ. Plant of room for extras. Has anyone found a Venty jacket (kept on while using) available in the US? Haven't dropped mine, but I'd rather be cautious.

Does that come with a heater stand, or have you found something to use as a heater stand (vs. just letting it sit in the coil, I guess)?

Received shipping info for order P99xx to the US this morning.

imgbb started working again! Couldn't get this to upload earlier (bamboo HI).

I recently got a bamboo HI. Can't compare it to a GTR (I only just got on the list), but I can take a picture later.

IDK how helpful this is since I've never used the full unit, but I find that the engine + adapter on a Ti MVS works great. Plenty of cooling and only a little heat transfer to the part of the stem closest to the bowl.

I'll echo some of the clamor for a wireless version of the ZX (ZXW?), recognizing that it's likely more complicated than just slapping a wireless handle on a ZX heater and putting a 16mm coil on a clamp.

I find that the mouthpiece gets a little warm, and I prefer to use the Simrell or VGoodiEZ 8mm adapter with a wooden MVS stem and mouthpiece. If you add the spinning components, you can also hit it one-handed while fluttering the carb by twisting the Venty slightly to get some fresh air in the...

Justifying this as my 'CBD on the way to & from the gym' vape. Really I'm a sucker for the insanely good deal, and I really like the dosing caps (I already use them in my Venty if I'm hitting it solo).

Thanks for the tips! I was thinking I'd prefer to use this as a one-and-done type of device (more toward the microdose end of the spectrum)