Recent content by roontoon

Question here. I am currently building my first half-pint. Are these solid wires on the outside used to connect to the momentary switch? Also on the flip side are those cuts to isolate these pads for that purpose? And wires connected to the flip side to the trace and the wire loop connected to...

I'm building a half-pint and somewhere I thought I saw a post about modifying the induction coil itself. Is there an optimal size, number of coils, etc?

You might want to consider a kit with directions. Try here. https://vapoven.com/build-your-own-dynavap-induction-heater/

How do you measure the WH and/or change the values to be suitable?

Any recommendations on the type of battery to get in terms of amperage and capacity? Flat or button top?

Thanks

So the momentary switch is across the two sides of the trace cut. Is there some info about the chokes and the capacitor hack? Thanks

Ok got it. So battery and switch wiring and you're good? Or are there other modifications I should know about?

So you are not using a ZVS board? Or are you building one?

Hi newbie here and I am interested in building a half-pint and I have a question. In the other DIY IH I have seen have a Mosfit as part of the build. Do you have a schematic that you can share? Thanks.