Recent content by PsySijk

Yeah I find its the side tabs rather than the ring that causes fit issues.

I suppose even if the hit is too hot you can draw air in through the corners of your mouth like a spoon pipe or something.

Damn sorry to hear you're having issues with the mod I didn't sand away the little catching ledge the screen is placed in. You could try a domed Arizer screen or another bucket/domed type screen.

Hmm very tempting to go carbless, whats the science behind the reduced drag on the draw? is it just the Vapcap performing well without a carb in general or does the extra length really make the odds?

Yeah no I agree with you, I can totally tell when I fuck up and combust from the crappy taste and carbonised black AVB. I was just saying Steama didn't offer up any response beyond "You're wrong" when this site is to explain away the myths and misconceptions about Vaping.

Hey I think threads like these are a great idea they get away from the overly happy almost infectious nature of the large threads that inevitably devolve into shipping questions and gear shots. Focusing more on quibbles, techniques and things to potentially make the vape better (something that...

People really need to lighten up, do the dtaxx mod if you can't wait my crafty mouthpiece has loosened up a bit and now fits fine. If you can wait it seems like multiple people have corroborated that Vivant has nearly fixed the issue. What's more likely that they spend the time effort and money...

Yeah I find that the Vapcap is too dry if I absolutely milk the carb without a waterpiece, so I end up getting feathering the carb and getting whispier hits. Love it through a bong though hits like a bong and I find it great between rounds in Street fighter or stages in DiRt Rally

Bearing in mind that they've given prototype test CU's to people to see if they hold up in everyday use. If they had issues with the new mouthpiece after sending them out to everyone they would be crucified on this forum. Keeping things under wraps until they are certain the issues are ironed...

Another crafty mod here, only had medium grit sandpaper so it took me a good 2 hours of sanding. Fits nice and tight, perhaps too tight and is ever so slightly off center when attached to the vape. But function is fine vaped two bowls through it and autocorrect is likely the only reason this...

Its worth pestering the seller assuming its from dhgate seller heavens gift, I got a replacement complete unit.

Because it fullfills a critical market point of per degree heating, replaceable batteries and low cost? I can buy 3 Alternates for the same cost as an Arizer Air or similar. Sure its not my only vape nor daily driver but you can't deny people's attraction to it.

Are the "tabs" the two interlocking plastic ridges on either side of the underside of the cooling unit?

Any ballpark figure for how much the Mouthpiece will cost + International shipping. Probably too early to say I know.

I did the same thing following my mouthpiece melting and I asked to confirm if it was a full unit and they said it was. I can dig up a screengrab for you if you want.