Recent content by nodrog

https://store.nvsglassworks.com/product/mobius-50t-v3/

So, the question is, if you blocked the hole with a metal screen, would a quartz banger work for vaporizing ground flower too, done exactly the same way as shown here?

THIS!!! And now I'm wondering if ceramic would be an option, and if so whether someone could simply ("simply") design and 3D print one. I already have this, by the way. The bowl for the Mobius Flower Pot vaporizer is a large glass bowl with a metal screen that fits tightly. Unfortunately, the...

Right. I leave my screen in the metal bowl 100% of the time. When I need to clean it, I drop the whole bowl assembly in a little dish of 99% ISO and let sit for a couple hours or overnight. Then, just rinse it out. I haven't taken the screen out of my bowl in nearly a year, but I clean it often.

It's like, functionally I like the metal bowl -- it's a little bigger, easier to stir the material, very little gets into the pipe with the double-weave screen. But aesthetially, I much prefer the glass bowl. It's quieter than metal-on-metal (sound matters to me), it looks nicer, and I can put...

Rather been liking the glass bowls for the Weedeater. BUT, the small provided screens fall out easily, and I may try trimming one of the titanium double weave screens to fit tightly. The glass screen's holes without a metal screen are too big (too much material falls through) and the thickness...

I keep going back and forth with the Weedeater between water and no water. Spent a few days using it with the Mobius Binary matrix and water, then returned to my regular use in a smaller dry pipe (the Mobius Nuc). Over and over again, I'm getting noticeably better effects without water. It...

Just want to say I've returned to dry hits, with the WE set at about 590. I'm getting optimally stoned like this!

Might want to look into the "Eusheen" or "Banjo" brands, those are nice and inexpensive.

On the scoop/tool tip, I've been incredibly pleased with this 3D printed scoop/poker. My main vape tool! https://delta3dstudios.com/scoop-n-poke-vape-tool-full-length/ Have been thinking about this so much. This is one of the most concise, easy-to-grasp explanations of the physics of vaping...

I too have been loving it dry, but wanting it cooler. Right now I'm running my WE at 580 through a dry SOL ashcatcher then into a regular glass bong. This dual-chamber setup provides enough time and contact with glass to cool it nicely. (Photos: https://www.instagram.com/p/B3Hn_g1n5oh/) But...

Thank you! I have had an enail before, and it seemed the range this one vacillates between is pretty big, but I'm not worried about it.

Question about the NewVape PID/controller: I have it set at 580 degrees. When I turn it on, it goes up to about 612, then down to about 560. Eventually it hovers closer to 580, but still fluctuates above and below that point quite a bit. Is this normal?

More low-temp adventures with the Weedeater: Continuing to experiment with gentle, slow DRY hits. Using the Mobius Nuc dry, I now have the temp set at just 575. It's awesome. Almost no coughing. With a super gentle and super slow draw the weed still gets nice and browned and I get just as stoned...

I've thought about it before, but never tried one. Thanks for the recommendation, I'll see how it shapes up! I'm actually now down to about 585 on the WE and if I simply draw slow enough, still getting nice clouds of vapor with even less coughing. It's like the secret, stealth mode of this...