Recent content by nodor

vc holds .1 gr. so 2 oz. of herb equals 560 loads so conservatively at 4 click per load not even close. My portable ih uses 6 18650 300ma cells and it won't come close to what they claim. Point being looks like a nice unit but specs are bullshit

Pipes I have built 2 IH following your design. Gotta say they sure make for consistent enjoyable vapes. The 18650 model takes longer to click due to voltage sag (12.6 to 10.6 under load) but the vape is superb. The desk top mains powered one stays constant at 12.2 volts. I have been looking for...

I believe that this is because genius george only makes a ss cap. In my IH it doesn't matter which tip I use it will click in 5.5 sec cold and 3.5 sec reheat. Titanium has higher resistance heats beyond what the cap says. When i'm using a titanium tip in the IH I go 4.5 sec and 2.5 sec and...

I used 200 mesh but they have 150,200,300,400 mesh at fasttech do a search for ss mesh. I think next time I order from them I'll splurge lol and grab a 150 mesh and maybe a 300 just to see if it makes any difference. I'm guessing that if the wires are finer in a higher mesh that they will heat...

Xclerk inside is my version of the dynacoil. I made them out of stainless steel mesh. I bought the mesh out of china for about 2.50 for a 5 ft roll. The width of the roll is perfect for the dynavap. I cut 4 inch strips and basically roll a crutch with 17 folds interlock the first and last...

Tried uploading pics b4 but didn't work so am trying tinypic Top tip is the purchased one

I agree with you but I think it would be clearer to refer to it as heat transfer. Purpose of the channels are to extract heat from the cap and body to draw thru the herb. To increase heat extracted more airflow is required. IMO what my homemade cap prooved to me is that doubling the amount of...

I have a M19 and bought a titanium tip for it. I was expecting a little more air flow. So I deciced to machine one with gr2 titanium. I went with 6 helical air flow paths same depth as the one I purchased. (it has 3 ). Alas it works great but still not really much difference in airflow

Yah ! brain fart here. That is what I meant cutaways not serpentine. LOL As far as the serpentine goes I machined out a tip of titanium and used 6 helix grooves to try and increase the airflow. I can't really feel any difference. The only bonus I got was that I decided that the weak point of the...

I found that when I use my IH with the micro switch that is activated by pushing the cap on it. The serpentine tip allows air to flow while the ordinary tip seals against the cap limiting the airflow. Thats why on the second one I built I mounted another switch to activate the unit.

MikeG7265 I found that it was better to remove the screen when doing concentrates. I have a dynacoil also but before they came out with the dynacoil I built my own. Made 30 of them and put a dab of concentrate on each store them in a plastic tube and I'm ready anytime with no mess. So my...

Hopla Great info keep it up I agree with what you say. I received my M19 and M18 karma a few days ago. I have a couple of IH units I built and they make testing more repeatable. I don't really get the point of the carb hole. Its not like you have a bong full of vapor to suck out. I found that I...

So my curosity has gotten the better of me. What is a karmavap ?