Recent content by Mr. Natural

If extraction is too fast, try mouth-to-lung hits, or shorter ones (I use 3-sec hits).

The Lobo is a beast at extraction! My typical session consists of 3-second DTL pulls, with temp setting at 400 F. The first pull is at 325, then around 360, and ending at 400. Power off, and use the residual heat for another 3-5 pulls. I get 2 sessions per lightly-loaded capsule with this...

Have been experimenting on my green lobo received 2 days ago. TODAY: 2 sessions on one loosley-packed capsule: Capsule Load: .06 gram 1st session: Heat up to 380 (w/cap): 47-50 sec. to temp (Three 3-second hits b4 shut-off; 3...

A new heating tip: a loosely packed half-bowl produced at least 2 good hits per heating cycle over 3 heating cycles, if I quickly (no more than 1-2 seconds) ran the coolest part of my jet lighter flame over the entire length of the bowl before heating the tip of the cap. “Pre-heating” the bowl...

Your bad experience with the o-rings would disappear if you substitute a Dynavap condenser for the Convector’s. It worked on the OG that came with my Ti convector.

Ordered the Ti Convector Oct. 18, and it got here on 10/23. Included a SS “OG” (cool!), but no second condenser. I inserted a DV condenser without a problem. I’m happy to say that after 6+ bowls, haven’t combusted once. After initial heating of 5-7 seconds, I wait 3-4 seconds, and give it...

Since I’m a confirmed half-bowl microdoser, I put a DV “B” tip on the Gen 2. Its stainless steel composition seems to hold onto heat better, and performs well with either torch (+fmj), or IH. I’m still working out which settings I like, but “full-flow” on the stem and medium flow on the...

Should read: “Dynavap and Eyce (silicone) spoon.”

Tried an Eyce spoon in combination with the B, as well as a Simrell Vortex. Both worked well to cool the vapor!

I’m humbled by your experience, and glad I could pique your curiosity!

The Dynavap B pairs well with many glass pieces because of the sealing ability of its silicone stem. So I tried it with a GRAV Pebble Pipe originally designed for combustion (below), and it works like a charm: enough internal area to cool vapor, but small enough to be pocket-sized. All it needed...

On a totally different subject, I was curious as to whether the medium grind that I got with my new mini mill could be reduced to a fine grind by re-milling it in my classic flower mill. It seems to work great! In the attached image, the medium grind is at the top, with the fine grind at the bottom.

The new “mini-mill” arrived today!

Well, I’m encouraged by this video, just out today…