Long term I think it’ll wear out the material faster if they are soaked long. I typically only soak the bowl. You shouldn’t notice a difference.
I always do fast soaks of silicone and the rinse them. Easy to replace if they do start to wear.
Tamping is personal preference. I fill a small amount and then I do make sure it's level so a light stir and tamp. I take multiple hits until there is no vapor or it tastes bad and I stir between the hits. I don't believe there is a "best" solution. Everyone is different and using different...
I clean the bowl using Powdered Brewers Wash. I use it to clean bangers and glass as well. Make a big batch and use it a week and then make another batch. Super clean. Easy peasy.
Every night before bed all the items go in the solution and then I rinse them in the morning. No fuss, no...
From my experience with vapes I tend to split them into dry herb and concentrate or oil vapes. I’ve tried a few different ball vape heads to use with concentrates and I’ve never found a really good experience. The way herb and oil vape is a bit different - herb stays in place while oil you...
X
I assume untwisted it a bit but that’s what I wanted to know. It may be better to redesign the outside of the ZX for wireless to improve coil contact.
Super cool wireless setup above. LOVE!! ❤️ ❤️❤️
The temps probably need to go higher to store enough heat energy for a couple of hits. Most wireless systems are being run hotter from what I’ve learned.
Even for a single hit the temp probably needs to rise a little bit.
They are the same material - same chemical composition. There are trace materials present that cause coloration. The actual gem is the same. Ruby typically refers to with chromium. The trace materials have no impact on thermal performance. It's visual.
Enjoy
Z-Tribe Maddy
The vape won't determine the draw restriction. The restriction will depend on the piece you. use it with. That's one of the reasons I think this is liked by so many. Some ball vapes do have restriction but I don't find any measurable restriction with the ZX. I pick a wide open bubbler and...
The funny thing about the wiring differences is that they are hooking up the same wires to different pins in the PID - it's a layout difference not an electrical one. They could all be the same as there is no electrical difference. I think there was a company that was trying to make a plug...