Recent content by jbm

Could all this delay be because we’re being assessed for tariffs?

Likewise. This whole process has been infected with delay.

If it’s a Dynavap stem it’ll fit.

The extraction engine fits 8mm stems. I’m putting it on a wood Vortex.

So is the oracle supposed to work equally well used wet or dry?

Ok, thanks. I’ve had other ball vapes where I was advised to burn off the coil at a high temp before use. But thanks for reminding me I should clean the glass beforehand.

Does the QC 18 coil require a burnoff before use?

I have the v2, that 50% off was hard to pass up.) Haven’t really tested it much yet, but will get back when I have a chance.

I’ve been wondering if this will be subject to tariff. I certainly hope not, but given how nuts this whole process has been…

The same.

I just grabbed one also. I like the look of the new stem but I have a nice Thuya burl vortex I think it will work well on.

I fell for this one too and not the Finn thing.

I don’t know that I’d call cutting the warranty by 2/3 with no notice to existing customers “quality,” but whatever. I have 2 v2s, one upgraded from an OG, and I like them, but I don’t have the same devotion to it that many people do. I actually find it a bit off putting.

Having been disappointed with v1 and very disappointed with the Flare, I think I’ll sit out the first round this time. I get tired of buying pre or newly released devices only to see a new version that works a couple months later.

After a week between the “shipping” email and the “label created” message the package was finally accepted and after 3 days is inbound into customs.