invertedisdead's latest activity

I picked up on this from you when I joined FC recently and is a big part of why I jumped on the phase3 train! I'm chuffed for my...

Given the imminent arrival of the ZXXL, I thought I'd offer up my old quartz 1.7 up to someone in the thread with the number of P3...

That's a solid lineup for sure :rockon: I'll definitely try and post one when I'm back in California to mail these orders out, I don't...

@invertedisdead With the ZXXL wireless about to release/ship out, will we be seeing any function videos of it in use? :brow: Really...

Yippee. I--for one--am all about the low-temp terpys hits myself. I am unfortunately (but somewhat predictably) between addresses at...

Maybe it’s the way I use it. I don’t like to pack deep bowls with the ZX. I like to fully extract small amounts in about 3 hits...

I also wanted a wireless ZX, but changed my mind. I tried two wireless ballvapes, and found this setup less precise than wired mode. So...

Love to see the engaging conversation, cheers everyone :wave: First off, good news, ZX ceramics have been rebuilt and are finally...

^^ that was my method too. Interesting so many have gone wireless with the zx. Do you all go for one hit extractions? Mine is still...

It's pretty easy to chop a dead (or sacrificial) coil to make the zx wireless:

Yeah if you keep the coil pretty tight it stays close to the wired temps for sure. And I think the ball chamber covered by the handle is...

ZX makes good contact with the coils even with the zip tie at the top. ZX is relatively long, and still hangs out the bottom of the...

I went with the easy mode.

:rofl: a couple pieces of scrap wood, a hacksaw, dremel, drill, stainless steel zip tie, a bolt with a matching hex nut and a matching...

I think it's weird to even call it a hack. Literally you just put a handle on it and heat it with a slightly open 16mm coil. It works...