Recent content by InhaleExhale

2+ years later and the ZX still reigns supreme in my arsenal! Thanks again for the smooth ride, @invertedisdead :bowdown::rockon::science: PS - still using the MAKO stem too. I don't use the Dynavap often (just when traveling) - the MAKO is my preferred stem. I will admit the MAKO is the...

Draw resistance was the term I was trying to explain. The SOLO 2 has some level of draw resistance that compounded through pulling through water can be a hard pull...but that would probably be more an issue for someone with COPD. The SOLO 2 turns on the heat when you draw, and yes the draw...

Have you had GERD flare-ups from smoking through a bong? Have you tried using the Solo 3 with just a stem and no water pipe, to see if there is any change? It requires slightly more effort to pull air through water so perhaps it's a reaction to the harder "pull". I've met a few (older) people...

I also leave my controller set to a constant temperature. When I want a flavor session over 10-15 minutes (hanging out at a campfire), that's when the Solo comes out. I have an Auber, but genuinely as long as your coil gets hot and the temp stays constant you are good to go. I think earlier...

I originally was fearful of the coil and the risk associated with it. However, I rationalized that women everywhere use curling (or straightening) irons and a coil is really similar. I cut a notch in a coffee mug with a diamond grinder wheel and that's what I use as my ZX stand. The ZX is in...

Bump to say PBW did a great job removing coffee scale from my thermos. PBW, hot water (185ºF) followed by a soaking got the insides from brown to silver in just an afternoon.

Check out Dfreez Designs coil handles too. Something different!

Yeah I've since done that...but the chance of dumping the bowl again gave me an aversion to using it that way. Fool me once shame on you...etc. In the end it was easier to use a hydratube or a short length of silicone hose with adapters instead of risking to dump the contents of an ELB.

I stopped using the EVO inverted after the basket cap fell out and dumped my herb into my water pipe! :doh::rolleyes:

I ordered SS BCG with all 3 plates on 4/11. It just arrived yesterday. I emailed them last week just to confirm status (it was 2 days short of 9 weeks) and they responded by that evening (would say response would be "within 24 hours"). I got my shipping notice the very next day. I have an...

Will a DV cap be provided, or will you need to bring your own? I'm definitely in. :nod: But don't have an armored cap...

This isn't a marketplace, it's an enthusiast site; and is run as such. The classifieds are for fellow enthusiasts to connect. Back-to-back posts are also frowned upon. Also read the Sales thread where the rules for selling are explained (including the post count requirement). :peace:

The important thing is making sure the XLR pin-out of any coil matches the configuration of your enail controller. See this page. I bought an Auber and a 16mm Disorderly Conduction coil from VGoodiez for my ZX (which came separately from Phase 3).

For sale I have an Ardent Flex unit. The Flex has never been used, and is in an unopened factory package. No trades, sorry! Finally, CONUS sales only; Paypal/Venmo or bankers check are only accepted methods of payment. Shipping will include tracking and insurance. Unused so you do not have...

Another fan of 14mm airpath. Would be in on a Phase 3 conduction-based desktop! To me, wireless is meh. The best part about tools that are plugged in is that the battery doesn't need recharging with constant access to power.