Recent content by humbuckers

There is no cutoff. New ideas arose from V1 feedback, leading to producing these new ideas, now planing on selling them. These new ideas are also easier to produce. Have you noticed how long V1 has been out of stock? Now to address the main point, upgrade kits are a gift sent from the vape...

“Use a standard sized screwdriver (2mm head) and shake the balls away from the center. Otherwise, a ball could get stuck and prevent you from turning it.”

Any try v2 head with v1 stem yet?

Have you tried removing the top indicator housing? There could be material inside causing this issue. This is how I fixed the same issue after dropping a hot tempest

V2 head compatible with V1 wand adapter?

Wouldn’t consider paying a penny in tariffs for any vape company other than mad heaters. I’ll probably have to pass because I’m broke as a joke. Not to get political but it’s a shame they are trying to abolish the department of education because some folks here clearly need it

If I’m not using it someone else can. Just a user, not a collector (other than memories)

Amazing products. Unrivaled customer service. Loving the first version. Can’t wait for the second. Probably my last vape purchase until the third

V2 head compatible with V1 stem?

Did you register the warranty? I had problems with my wand and they (dynavap) shipped a replacement the very next day

Half bowl boro balls for me. Full bowl I couldn’t overpack. Half bowl I can stuff to my hearts desire AND get better results

Dynavap silicone adapter fits in the 20mm coil. Might take adapter out of wand and do some experimenting

Anyone try a smaller hot coil as a heat source? Do they make them small enough? Only have one for zeal

Hercules? That you? Jokes aside you can use dyna adapter with 2nd temp setting and pull at the click or when it stops blinking

If the reload had a magnet on the bottom and an additional magnet other side of cap that would be so great. Use existing reload magnet on opposite end, level it with bottom. Add another magnet inside of the cap, level to the end. The tool (flathead de-bowler) might have to be shorter so this...