highvaper's latest activity

i feel for you. i save most of my injuries for the wood shop - tried to remove three finger tips when a dull 1/4" drill bit seized a...

Take a read of the other thread about a regulated version there is no end goal As mentioned the large tube version wont work with the...

I have been able to drill the boro but isnt quartz that much tougher? Just gave the new longer open tube heater a go with some new...

Yes i have avoided solder from day 1 of the builds - i suppose pure silver may be an option if i needed to join stuff near high temp...

Well i am really struggling to make the same piece again and it seems the first one was a bit of a fluke. No matter what tool or cut i...

Your forgetting about the part of the vape before goes through the weed and gets vapour - ie the air intake when its cold - if drawing...

Good idea. That's what i ended up doing with a small Milwaukee circular saw i had. It was originally NiCd but of course no...

Literally ordered some of those mini volt meters earlier today

@Flotsam thanks for the concern - i am keeping an eye on the min voltage after a session to make sure they dont drop too low - i have...

Its ‎Uxcell - nichrome 80 I rekon for a really cheap version you could use some old toaster element. I havent got any hash or oil at...

@Hippie Dickie - my regulated one is using the 3mm nichrome and has been working well - thank you for putting me on to the nichrome. I...

i use slightly narrower nichrome ribbon - at 1/8" (3mm) - and it is about 0.3 ohm for 13" length. make sure the battery can deliver the...

Thanks for the update

Been testing a fair bit - has a nice heat profile - the heaters outer layer of glass keeps the heat in much better than my regulated...

Inspired by work on the regulated version on this thread...