Our Cyber Monday sale is still going strong through this week.
GET YOURSELF A HAMMER FOR ONLY $35!!!
https://www.thehammervaporizer.com/collections/vaporizers/products/hammer-pro-vaporizer
Also, you need to apply the concentrate all the way inside the heat exchanger...
only the very center of the heat exchanger gets hot enough
Your stem should be empty so combustion is not an issue
Looks like I need to address a few things...
Unfortunately, the Hammer PRO does not have a lock for the igniter. I actually have a couple of samples that you turn on the fuel and then click the button to ignite it. These units stay lit until you turn off the fuel (no need to hold the...
The Hammer PRO does actually include few tweaks to the heat exchanger for better use with concentrates. However, the original Hammers will also perform the job without any issues.
If you haven't tried your Hammer with concentrates... You are missing out!
Seriously better than any rig setup...
My apologies to you Scott... we did receive your email, but were a bit distracted by the launch of the campaign. I have a solution to your problem and will reply to you asap.
NO MORE wispy HITS
David
That's awesome! I actually have an early prototype of the hammer with a more ergonomic handle, but we decided that it was too bulky and went for the smaller size
I have a bunch of new custom stems that are ready to go on the website, but all of them use screens. I will try to get some screenless ones made in the next week.
@paytonpenn BRILLIANT!!! I tried something similar... It did work, but your method is much easier. The only thing to consider is that since the torch only heats the middle, the ends of the heat exchanger will eventually get very dirty inside. Also, I would suggest is to use something else...
Just got back in town... was spending some quality time with my Hammer :D
@Vapodudule It sounds like your Hammers just needed to be purged and refilled with fresh butane. Air in the fuel tank can cause the issues that you mentioned (new Hammers have air trapped in the tank during...
I am glad that you got it tuned to your liking.... but am surprised that it was necessary. We fill each hammer with butane and tune it prior to shipment.
Since we don't know the final destination of each hammer, we try to set each one so that it can be used in a very broad range of conditions...